Replacing Image Transfer Roller Unit & Paper Dust/Ozone Remover

check the right door the sponge looking roller and area around it for a problem that section is call registration aligning the paper up before the image goes on it the sponge roller actually trans fer the image on to the paper so the problem is before it check the mylar clear plastic before the the transfer roller section should be on the assembly or below it also check the paper dust remover it clips in on the assy.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Open the right side door and check for proper insertion of Paper dust remover beside transfer roller. Not proper inserted Paper dust remover cause paper to jumping register roller.

can you explain more the functions of each are as followed fuser melts the toner to the paper so it dosnt rub off ozone filter filters out the ozone so you don't get headaches and turn al the rollers to bubble gum transfer roller pushes the paper onto the transfer belt applying the image to the paper and imagine unit is where thetransfer belt gets the image from

Sir/Mam,
#10 Transfer roller needs replacing sponge looking roller right side of the of the machine when you open to remove paper jams.

# 9 Developing unit needs replacement that the part that holds the drum and developer/toner. IF YOU YANK THIS UNIT OUT WITHOUT REMOVING THE LITTLE COVER ONE BOLT and DICONNECT THE CONNECTOR. BIG TROUBLE, going to cost a lot to repair.

#8 PAPER DUST REMOVER the device that collect paper dust yes paper does produce DUST. Just before the sponge roller

#6 IS Warning that the developer has not been replace inside the drum cartridge. SEE #9

#4 Drum need to be replaced.

Really have to watch for all of that sir/mam.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

need to replace transfer roller

Press "utility/counter" then "details" then stop, 0, 0, stop, 0, 1
This gets you into service mode.
Then press Counter the Life.
Be very careful not to mess with much in the service mode tho.
Good Luck andThank You for using Fixya

I believe the filter is located on the right or left side. The "Transfer Roller Unit" is the foam roller inside the right door.

I would advise having a copier technician replace those items it is not that hard to do but if you dont get the roller seated in the holder properly it can destroy the transfer belt and that could get expensive

In Service Mode -> Counter -> Life -> Select the one you want to reset and press 'C'

You need to go into tech rep mode to reset.
press: stop 0 0 stop 0 1, then 0 0 0 0 0 0 0 0, press enter, then press counter on the left, select life, then highlight image trans roller and press the C button, repeat for paper dust remover and exit tech rep mode