LST 216A hotpoint integrated slimline missing assembly sheet

bad control board probably

heater element should only be held in by 1 bolt which runs from inside to outside element faxe......remove the nut..........carfully prise the element out...its only kept in place by rubber ..washing up liquid may help.......

cheers

http://www.fixya.com/answer/answerpageslideview.aspx?thid=8089051&ctg=26http://www.fixya.com/answer/answerpageslideview.aspx?thid=8089051&ctg=26&lst=1#&lst=1#

Hi,

Based on your symptom the touch panel likely has a stuck or shorted push button. In order to confirm if the console assembly has a stuck of shorted key pad you will need to disconnect the power supply, remove the console and disconnect the ribbon connector that connects the console assembly to the control board. To diagnose if the Smart wash button is stuck of shorted it will require an ohm meter. I recommend calling a service technician to diagnose and repair your dishwasher.

Hope this helps.

Please revert back if you have any further queries .

Shane

Panasonic Cordless Telephone KX-TGA101CS

Find your exact model on this web site and get the manual.
I can't locate your number.
Gary

download the user guide here >> http://kitchen.manualsonline.com/manuals/mfg/hotpoint/hotpoint_dishwasher_product_list.html

hi hears a driver page for your cam
http://www.nodevice.com/driver/P-216A-09/get47242.html


good luck

There is a Tech Sheet inside the control console that describes the dis-assembly.

replace the FLASH IC in your unit,, it is the hardware of integrated circuit that has defects, you must replace it an branded which compatible to your UNIT!!!

This a generic problem with hotpoint dishwashers..
Water is present in the flood catching tray at the bottom which usually indicates that there is a leak somewhere. More often than not this is just a pipe with a poor fitting and simply tightening the clip is enough to stop the leak. Our machine had a very slow leak from one pipe (not enough to trigger the alarm) which was fixed in this way. The leak is detected by a small float switch located in the flood catch tray.

Undo 4 screws on the metal plate under the dishwasher 3 at the front 1 at the back, this reveals The pump check the seals are in place on the waste pump.