Flashing fault code F13

I am 99% positive you need a new EOC based on the fact that you said you heard the all too common pop noise. EOCs usually cost around $200-$300 and sometimes more. The EOC in this is the same as your clock, if you took off the top back you will see burn marks on the back of the clock.

You have a shorted out keypad - (F11, 12, & 13) disconnect power, wait 30 seconds and reapply power. If fault returns upon power-up, replace EOC

Disconnect power, wait 30 seconds and reapply power. If fault returns uponpower-up, replace EOC

Disconnect power, wait 30 seconds and reapply power.

If the error code returns upon power up, replace the EOC (electronic oven control).

- The part number for the EOC is AP3770108

- The part number for the overlay is AP3772261

F11, 12 & 13) Disconnect power, wait 30 seconds and reapply
power. If fault returns upon power-up, replace EOC.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hi william_j522,

the F13 error is related to the clock. this error can occur when the clock looses communication between the keypad or any of the sensor in the stove, including the heat probe. sometimes resetting the power will fix the problem.

try disconnecting power to the stove completely and flip the corresponding breaker on and off on the breaker box. 
wait 30 seconds and than turn everything back on.
if the problem returns after power-up, replace the clock.

Regards
R.K.

F-13

Control's internal memory may have
become corrupted.

1- Press Cancel key.
2- If fault returns disconnect power, wait 30 seconds and
reapply power.
3- If the problem persists upon power-up replace the display
board.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/craig_3fa289bf857b1a3c

Hi danair2,

the F13 error is related to the clock. this error can occur when the clock looses communication between the keypad or any of the sensor in the stove, including the heat probe. sometimes resetting the power will fix the problem.

try disconnecting power to the stove completely and flip the corresponding breaker on and off on the breaker box. 
wait 30 seconds and than turn everything back on.
if the problem returns after power-up, replace the clock.

Regards
R.K.

The F13 indicates a problem with the EOC (Electronic Oven Control board). This can be caused by a power surge or glitch through the electrical supply lines. You can try disconnecting electrical power completely from the range by unplugging it. Leave it unplugged for a few minutes. If the fault code returns when you plug the range back in, then the EOC will need to be replaced.

hi there,

the F13 error is related to the clock. this error can occur when the clock looses communication between the keypad or any of the sensor in the stove, including the heat probe. sometimes resetting the power will fix the problem.

here is what you can do:

disconnect power to the stove completely and flip the corresponding breaker on and off on the breaker box.
wait 30 seconds and than turn everything back on.
if the problem returns after power-up, replace the clock.

let me know if this helps.