Error code COF 32

Need the change a developer.After 40000 copies the developer,OPC drum,Drum cleaning blade and the imaging unit fuser(SOME MODELS) need to change.Please the copier model for another instructions.

Has the developer been replaced along with the drum They are normally replaced as one. If not that is why it is coding out. If not with power off then on have tech come out and replace the developer and drum mite require the sensor in the developer cartridge mite be bad.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Cof 32-34 ATDC sensor failure. verify the sensor conections and the developer nivel.

ATDC sensor malfunction.Try to change the ATDC sensor gain adjustment value,increase or decrease.If the error persist you must be change the developer and the perform the F8(developer and ATDC semsor initialization).To reset please tell me the copier model.

ATDC sensor problem.If dont have reset,change the developer and perform F8 for new developer.

Cof 024 - AIDC sensor contamination correction failure.The photosensore LED located under OPC drum of the AIDC sensor dirty.Clean the sensor,reset the malfunction code if the necessary perform F5 AIDC auto adjustment.

COF 32 ATDC sensor failure.Enter in the service mode select Then.rep.mode select printer mode select ATDC gain adjustment note the current value then clear the current value and change the value up or down.Ex: the current value = 150 clear and change to 154 ,make a few copy and if the error code not displayed is OK.If the error code is appaire clear the value and enter 132,make a feww copy,if OK you are resolved a problem.
Service mode entering:
press utility key-press metercount-press details(if apaire the details windows)-press Stop 0 0 Stop 0 1 (if appaure admin code press 00000000 ) select techn.rep.mode-printer etc.

did you replace the developer also did you clear the counters first did you run the F8

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

how the code appeared?
I suppose you worked with the cyan low toner attention untill the machine stopped. in this case you should make an ATDC sensor adjustement! but firstly you should reset the error!

sry, cant find this code