Nustart remote starter wont work

If ur check engine light is on it wont let the remote starter work

your also suppose to hit door lock 2x before start and if alarm still goes off problem with fob or your aftermarket alarm programming

the remote battery is probably dead as well

yep needs to be reprogrammed ...

Your remote is in valet mode...search google for the manual

The starter need a lot more charge to crank the engine then lights, door lock and other auxiliary equipment. So it could be a battery. Try jump wire your car. If this does not help - check the starter relay in the relay box of engine compartment.

sounds like a dirty remote. if you open it up and clean the contacts with rubbing alcahol (get the back side of the rubber as well) it should help

I would suspect bad components in your starter; the armature and brushes. These parts are replaceable and some starters are easier to rebuild than others. I wouldn't think the remote starting circuit could cause this - just bad timing!! It may be cost effective to just change out the starter / solenoid combo depending on the price - it certainly would be faster and easier!!
If you want to change out those parts you just have to remove the end cap on the starter ( after removing the starter from the vehicle) , pull out the armature and unbolt the brushes. The brushes are sized differently so you should pay attention to which side has the long lip and which has the short.

Hi.

Go to this site I wrote an article about repairing remote controls.

http://www.ehow.com/how_2094701_tvvcrcabledvd-remote-control-quick-easy.html


http://dysonmanuals.llc.nu/

Chris.

Hi.
On the sky box do the following.

Check scart to tv is in the correct socket marked TV.
Try pressing services
then system setup
then picture settings.
Then try switching scart control to on or off.
If this sorts it great. If it doesnt check scart lead has all pins wired & not only A few.

http://dysonmanuals.llc.nu

Chris..