Remove the finisher/bridge unit - Lanier Office Equipment & Supplies

Check these sites out....

https://www.google.com/search?q=attaching+bridge+to+gutar+body


Best to you.

The machine does not recognize the finisher, but recognizes the bridge unit .check the connections between the finisher and the machine.the next solution is to.install a new finisher

The machine does not recognize the finisher, but recognizes the bridge unit.

• Defective connector

• Defective harness
• Incorrect installation

• Defective connector

• Defective harness
• Incorrect installation

This error code can mean several things. However the most likely problem has do do with the finisher attached to the copier unit. The finisher may have been disconnected to the bridge unit or lost power. Check your connections to the finisher and make sure it latched to the main unit properly.

If you live in Southeast Florida Advanced business computers is a great source for help. Computer network repair, printer and copier maintenance repairs, leasing and supplies.

finisher cable not plug into copier. I f you don't have a finisher don't worry about it or you need to remove bridge unit to get rid of code.

• Description:Bridge unit error
  The machine recognizes the finisher, but does not the bridge unit.
• Causes:Defective connector. Broken harness.
• Remedy:1. Check the connections between the bridge unit and the machine. 2. Install a new bridge unit.

792 Finisher connection error
Symptom:
The SBCU cannot communicate with
the finisher properly when the bridge
unit is installed.

Possible Cause:
• Poor connection between the finisher
and bridge unit
• SBCU board defective

Is this a ricoh machine? If so you need to eathier put the finisher back on the machine or remove the bridge unit. The bridge unit is the section in the middle of the copier where the paper comes out. Make sure you turn off the machine and unplug it while removing the bridge unit or while connecting the finisher. Let me know if you need more help.

Hello sir; try to turn off and back on the machine to reset, if don't work next few steps need to follow;
1, press "clear mode" then enter 107 then press and hold "clear/stop" key until SP mode show up.
2, turn power off and back on .

possible toner pump