P21 appears during warming up, ineo +200 - Konica Minolta Bizhub c203 Copier

Check the transfer roller located across from the drum

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

http://farbtoner.com/develop-ineo-c-200.html?language=en

check The Transfer Belt or it can be the Black Image Unit . (P9 & P21 normally: black Imaging unit) but P21 can also be refered to Transfer Belt). ..

check behind the paper draws for paper stuck also remove any paper from the left side of the draw not a storage area but for 11 x 17 paper

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

you need to replace the image units Black cyan yellow and magenta

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

You must press Utylity/Counter next open on screen admin setting. (Pass is 12345678) next network setting, IP setting and you can set IP address. If network (card, cable, switch or router) are OK you can print on your Develop. Driver you find on www.develop.de or http://www.konicaminolta.eu/en/business-solutions/support/download-center.html

main board problem

Q10. In layman's terms, resveratrol is one of the many ingredients that can protect our systems in the harmful impacts of pollution, UV light, air, nitrogen and moment.


http://www.trueplusgarciniatry.com/alpha-f1/

hi piz Error code P9 and P21 appears on screen and when printing or photocopying using color black, blank copies are outputed

either the hot water solenoid is w/o power or is defective and you need to check its coil for power and then coil continuity,if some warm water is getting by the valve your washer screen in the hose may be plugged,replace them both,hot and cold