Bell Northwest. 5.8 GHz Cordless Phone... Problem

Check the side of the phone. Look for TONE / PULSE selection.

MOVE it back and forth and leave it to TONE.

Test it again,

Contact your Phone Carrier.

usually this means you have voicemail...listen to the messages and delete them and the beeps should go away...

I would try to reregister the handset. It's on page 40 of the instruction manual. Here's a link to the manual.

http://service.us.panasonic.com/OPERMANPDF/KXTG5421S.pdf

Good luck!

what ever you sent this statement to fixya site on , send an e-mail to your service provide notifying of line failure and request a repair team out

Google; "Bell Telephone 36028 free user guide"

Third selection is; Product Manual in PDF format; Click on this choice and manual loads. Then save pdf file.

[email protected]


I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Here's what the manual says: Changing the Dial Mode (Tone or Pulse Dialing) (HS1 only) Your phone can communicate with the telephone network in two different ways: tone dialing or pulse dialing. These days, most phone networks use a method called tone dialing, so your phone comes programmed for tone dialing. If your phone company uses pulse dialing, you need to change your phone's dial mode. If you don't get a dial tone or can't connect to the telephone network, follow the steps below to modify your phone?s settings: With the phone in standby, press and hold [cid/menu]. Press [vol/ / ] to move the pointer to select DIAL. Press [select/channel] to set the phone to pulse dialing. Press [end]. Return the handset to the base. The handset communicates the new setting to the base, and the base activates the setting on any other handsets. Hope this helps out. K

It may not be registed with the main unit. You may need to register the handset. With my uniden all i have to do is put it in the main base until it says what handset it is (it should be a number).

If you have any questions please dont hesitate to ask

Lisa, If the 900MHZ phone is Model 26928M programming for rotary dial usually goes like below, can't hurt to try on any model. TONE/PULSE DIALING This adjustment allows you to select tone (touch-tone) or pulse (rotary) mode dialing. The phone is pre-set for touch-tone use. To set to tone or pulse dialing: 1. Press and hold the program button for two seconds. You will hear a beep. 2. Press the *tone button to select Tone Dialing or press #pause to select Pulse Dialing. 3. Press the program button again. You will hear a confirmation tone.

Do your Dial tone sound different. Your phone listens to the dial tone. if you have a new voice mail your dial tone changes.and your phone does the flashy thing accordingly. Contact your phone company.