Question about Life Fitness Exercise & Fitness

1 Answer

How to replace a battery on the life fitness 5500 stepper

Opened battery case and there is nothing in there to hold the battery in

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Life Fitness Master
  • 918 Answers

Replacement Parts for Fitness Exercise Equipment at SPORTSMITH

Some of these units have 9 volt battery found in the back of the console. Also some of these units that do not have the 9 volt battery, still used the same console shell. If you have an empty spot with no wiring in it, then you are fully relying on your external power supply. I am attaching a link to the picture of the back of the console I am referencing. CASE BATTERY DOOR 0K36 01187 0001 SPORTSMITH net

Posted on Sep 30, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 chevy Silverado code CO321 transfer lock circuit failed


DTC C0321 01: Transfer Case Lock Circuit Short to Battery
DTC C0321 02: Transfer Case Lock Circuit Short to Ground
DTC C0321 04: Transfer Case Lock Circuit Open
DTC C0321 08: Transfer Case Lock Circuit Signal Invalid

The transfer case shift control module controls the transfer case lock solenoid.
The transfer case lock solenoid is released by being energized. This is accomplished by grounding the lock solenoid control circuit during gears shifts, and in the AUTO 4WD mode. Locking action is applied when power or ground are taken away from the lock solenoid, the transfer case motor is prevented from moving. The system is capable of providing a 2HI, 4HI and 4LO lock-up without the need of additional vehicle power to hold the transfer case in these positions.
This DTC detects an open lock solenoid coil, open motor lock control circuit, or an open batter positive voltage circuit, or a short to voltage or ground on the lock solenoid control circuit.


Circuit/System Testing
The battery positive voltage circuit and the lock solenoid control circuit must be tested for opens, shorts to ground, shorts to voltage, and high resistance. This can also result from a electrically faulted solenoid.
With the ignition on check which DTC is set. If DTC C0321 is set with failure type byte 04 then do the following.
? The transfer case lock is unable to hold during a hold test and the transfer case actuator will need to be replaced, and the motor learn procedure performed. If this is not the case continue to the next step.
Disconnect the transfer case actuator, turn on the ignition and with a DMM check the battery positive voltage circuit for battery voltage at the transfer case actuator.
? If battery voltage is not seen then repair the battery positive voltage circuit for an open or high resistance. If the circuit checks out proceed to the next step.
Disconnect the transfer case control module connector X2 and check the circuit for an open, high resistance, short to ground, or short to voltage. If condition is found repair the circuit or inline connector 109 as necessary, if the condition is not found refer to component testing.

May 18, 2018 | Cars & Trucks

Tip

How to replace your ipod battery


1. buy a new battery
2. open ipod (where it joins up) with thin pice of plastic or metal
3. there will be clips holding then together. push them in and they will open.
4. open ipod carefully because there a ribon cable holding each side together
5. carefully remove the hardrive, (should have a rubber protection around it) by lifting the cable socket.
6. removie battery carefully with thin plastic or metal. try not to touch the circuit board underneath.
7. disconnect wire from ipod case. (pull them from socket)
8. attatch the new battery
9. put back in hardrive
10. put case back on and your all set.

on Feb 17, 2010 | Audio Players & Recorders

1 Answer

Gateway DX-4380 won't start up but the fans begin for 1-2 seconds than stop.


unplug pc, hold power button in for a few seconds, open case, remove cmos battery ( looks like a watch battery) put battery back, start pc. If that does not work then unplug all hardware (cd drives) and try again to see if maybe it is a drive. If nothing works then its a good chance that your motherboard is bad.

Aug 20, 2014 | Computers & Internet

1 Answer

Where can i find the batteries on an older model lifestyles stepper


Repair Parts for LifeFitness Steppers Belts Batteries Springs SPORTSMITH...

Please have your model and serial number available. We may have the diagram for your stepper. This will show you the location for your battery.

Apr 24, 2014 | Life Fitness Exercise & Fitness

1 Answer

Not charging and will not turn on


My son's PSP 2001 had the same problem if it was not in a hard case--the battery wouldn't charge and the PSP would not turn on. All we could figure was that something inside the battery area was loose and the snap-on case held the battery in place better. Try putting the battery in and holding the battery cover on firmly with your hand. If it charges and/or turns on while you're holding it like that, you might want to buy a case to sort of hold it together better. I think they loosen up over time and useage.

Jan 14, 2014 | Sony PSP-2001

1 Answer

My 95si will not turn on


Replacement Parts for Fitness Exercise Equipment at SPORTSMITH

You may want to start with checking the voltage output from your power supply. I am attaching a video of how to use a multimeter.

Jan 03, 2014 | Life Fitness Used Stepper 95Si

1 Answer

Star trac sc4100


Replacement Parts for Fitness Exercise Equipment at SPORTSMITH

The following link will take you to the items we have available for your Star Trac SC4100. You can use the tabs on this page to see an owners manual, service manual and a diagram.

Star Trac Unisen Stepper Parts for Star Stepper SC3100 SC4100 SPORTSMITH...

Aug 14, 2013 | Exercise & Fitness

1 Answer

My camera wil not start, he does nothing at all, the battery is loaded. What can I do.


Before doing anything else be sure the battery is actually capable of holding a charge. Worn out batteries charge very quickly in the charger. A healthy battery will take several hours to charge.

When a "charged" worn out battery is put into the camera battery voltage drops instantly when the camera tries to start from it - nothing happens in this case.

Jul 04, 2011 | Canon IXUS 960 IS Digital Camera

1 Answer

My B&D GrassHog CST2000 doesn't hold a charge very


Battery cases are usually welded closed and must be cut open to access the cells. The cells are also spot welded together to make up the battery voltage.

Jun 01, 2011 | Black & Decker Garden

Not finding what you are looking for?
Exercise & Fitness Logo

Related Topics:

578 people viewed this question

Ask a Question

Usually answered in minutes!

Top Life Fitness Exercise & Fitness Experts

Vincent G
Vincent G

Level 3 Expert

2361 Answers

Android Man
Android Man

Level 2 Expert

278 Answers

Kenneth Simmons

Level 3 Expert

931 Answers

Are you a Life Fitness Exercise and Fitnes Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...