At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I will turn my tv on and exactly 1 minute goes by and my tv will go to standby mode. After 30 secounds the tv will turn back on. This continues until I turn the tv off. I dont know whats going on?
I have a KF-50XBR800. TV turns off after one minute goes into standby mode. Only the standby light flashes and then it turns back on in about 30 seconds then off in a minute. I think it might be a bad fan, is it easy to change?'
Thanks
I have a KF-50XBR800. TV turns off after one minute goes into standby mode. Only the standby light flashes and then it turns back on in about 30 seconds then off in a minute. I think it might be a bad fan, is it easy to change?'
I have a KF-50XBR800. TV turns off after one minute goes into standby mode. Only the standby light flashes and then it turns back on in about 30 seconds then off in a minute. I think it might be a bad fan, is it easy to change?'
ThanksI have a KF-50XBR800. TV turns off after one minute goes into standby mode. Only the standby light flashes and then it turns back on in about 30 seconds then off in a minute. I think it might be a bad fan, is it easy to change?'
Thanks
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Sep 12, 2014 - Our TV turns off and on without warning on its own. The standby lights starts to blink and the picture and sound go out, then 30 seconds to a ...
Jan 19, 2009 - 14 posts - 11 authors
I recently got a 60 inch Sony KDF-E60A20 from a friend for around. ... runs for about 1 minutes then goes black(no picture no sounds), then the picture and sound come right back on for another minutes then off for 30 seconds.
Fault with its main board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/ . In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.
these particular tvs are very sensitive to voltage changes spikes etc.first turn off main power switch wait at least 30 sec if standby come on wait another 30 then turn off main power again and unplug tv for 1 min then plug in turn on main switch wait 30 sec then turn on tv with remote resets system.then buy a ups and always wait at least 30 min after turning tv off to turn back on if not causes power failure and after each press of power button wait 30 seconds before trying again lmk good luck
The remote control will not operate the TV when the TV is in the OFF mode (No LED lit on front bezel). To change the mode from OFF to STANDBY or ON, press the POWER button on the side of the TV. Once the POWER button is pressed, the LED will change to either red to indicate STANDBY or green to indicate ON, whichever mode the TV was in prior to being turned off with the TV POWER button.
By pressing the POWER button on the side of the TV, the mode will toggle from OFF to either STANDBY or ON. If the POWER button is pressed and then the LED on the bezel is red, the TV is in STANDBY mode and will need to be turned on using the remote control. If the POWER button is pressed and then the LED on the bezel is green, the TV is ON.
I finally managed to solve this problem by unplugging everything - scarts - HDD cables - power etc and left it for an hour. When I turned it back on again the problem had sorted itself out.
tv works for about 2 minutes, then shuts itself off. the red standby light flashes 50 times, then the tv. comes back on for approximetly 2 minutes then goes off again, only to repeat again
Unplug the TV for maybe 10 minutes, then turn it on. Sometimes these units simply need to recycle. If that doesn't work, you've likely got serious problems.
Your problem is in the switch mode power supply or the horizontal out circut.
sometimes the small CHOKE that feeds the base of the horz. out transistor has a cold solder joint.
resolder both ends first.
Thanks Guy9
I have a KF-50XBR800. TV turns off after one minute goes into standby mode. Only the standby light flashes and then it turns back on in about 30 seconds then off in a minute. I think it might be a bad fan, is it easy to change?'
Thanks
I have a KF-50XBR800. TV turns off after one minute goes into standby mode. Only the standby light flashes and then it turns back on in about 30 seconds then off in a minute. I think it might be a bad fan, is it easy to change?'
Thanks
×