Network Problem (occasionally loss)

It is your phone mic need to be replaced or has some loss connection. As that problem happens sometimes " the mic connection to phone board connect sometimes and lose sometimes"

it can be network chip also need to he replaced. As when you hang up and call again it fix the problem . And usually it is where the fault

get technician to repair.

RED FAULT ON - No contact with network.
OFF- Normal.
SLOW BLINK - Loss of communication with the panel (ECP fault).
FAST BLINK - No network contact AND loss of communication with the panel.

YELLOW MESSAGE ON - Message transmission pending.
QUICK PERIODIC BLINK - Normal
FAST BLINK - Message waiting for network ACK.
SLOW BLINK - In unison with green LED - Registration in progress.


Hope this helps, all of this was found in the manual :P

http://site.geoarm.com/pdfs/Honeywell/gsmvlp-install-guide.pdf

too high load on bad Connection line

if there is no netework adapter in device manager or any device that is not instaled try checking in BIOS if it is enabled. sometimes after power loss bios is reset. if it is enabled in BIOS that short power outage probably killed your network adapter. you can add some PCI network adapter and solve your problem.

Try This: Go to settings Select General Select Network Check that WiFi is on Choose Network If network is hidden then select other..there you will put in the SSID of your linksys and the type of security protocol that has been set
If Network name is showing then select the more arrow select renew lease if IP configuration settings are appearing If settings are not appearing select forget network
Go back to general settings and select network again select wi fi see if the network name appears go to the more arrow check network settings to see if the device has acquired ip settings
You may have to do this occasionally when connecting to various hotspots

Most wireless adapters will get hot during use.

Obviously the cooler it stays, the better it will operate and the longer it will last, but as long as there is adequate air flow around the device for cooling and the ambient temperature is reasonable, it should not be a problem.

Excessive heat may cause occasional loss of signal / connection or even total failure eventually, but unless the unit becomes to hot to even touch, it should continue to operate normally.

Hope that was helpful.

try reinstall network adapter driver, is din't cahange anything reinstall your pc

flaky network card

Did you loose the network key so now u cant connect to your router or you cant access the admin area of your router!

In case that its the network key u can run the wizard again in admin area and reset your network key!

it may be as simple as the wireless connection signal strength, as doors, solid walls or any solid object that is in it's line will cause the signal to be very low, and at that point it will disconect from the internet as it is unable to send packets of information to your wireless card from the router. You can try your router in another telephone point that is nearer the pc to see if the connection drops, or use a different channel number which can be changed in the routers settings and the wireless cards properties as interference from other electrical appliances on the MHZ level can cause signal loss. Laptops tend to suffer less with the signal loss because they normally have a signal booster in the screen of the laptop within the wireless receiver ariel.