Getting E93 error message on frigidaire dryer

What exactly is the issue? Is the compressor running? Refrigerator warmer than normal? Specifics needed!

E64 means Heater Open Circuit. Either your heater coil is blown or you have some bad wiring to the heater coil.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/john_32f4b76dad4781c4

Good Morning Yasmin Abdullah, I am happy to assist you!

Based off the information you have provided your Frigidaire dryer is displaying error code "E64". "E63" typically stands for heater open circuit, which means that it could be a faulty wiring harness or heater. I would suggest performing a reset on your dryer by disconnecting power from it for ten minutes. This could be a false error code or a miscommunication within the board and a reset will help to clear that out. I hope this information is helpful to some degree. -Matt

Hello Friend, this is Z. I appreciate your post!

To get the error code your dryer may be experiencing, attempt the following:

Wake your dryer by pressing any button except for CANCEL.

Press and hold the "CANCEL" and "START PAUSE" buttons simultaneously for 6 seconds to show the error recorder code your dryer may have. The error code normally appears in the display as an E followed by two numbers.

If your dryer shoes, E00 it indicates no failure code was detected.

I ask that you please follow up with a comment on the post, at your convenience, to advise if you receive an error and if further troubleshooting is needed.

Thank you!

Good Afternoon Carolyn, this is Z. I am happy to assist you!

I see that you are receiving an error code E93 on your Electrolux dryer. Typically this indicates that the main control board has possibly gone bad or is not communicating correctly. I would suggest resetting power to your dryer for roughly ten minutes. If the error code still displays, at this point, I strongly recommend connecting with a local appliance tech that has the expertise to distinguish which part is the culprit. I hope this information proves useful.

Heater has an open circuit and need to be replaced. Here is the part you need.

This should help ....
Frigidaire Dryer Error Code E68 How to Troubleshoot and Repair

Good luck on your trouble shooting!

E68 error refers to "Current leakage to ground on heater or fuse opened".Problem with the fuse.Try getting it replaced.This can be done by any local repairman.Need not be a technician from Frigidaire,as they charge a lot for servicing. Good luck with the machine.Please do post results and comments.

power failure...reset breaker for dryer restart cycle then it should be g00d!!!!!!