HOW DO I PUT NEW STRING ON MY TB425CS TRIMMER?
There are two ways to install the string..the cool way is without pulling the inner reel off the trimmer..just leave it in place..cut (2) approx.two arms length (thats spreading your arms out like airplane wings) of .095 string..now, align the arrow of the inner reel (it turns counter clock-wise..the arrow points outward) with the arrow on the outer spool (pointing inward)..holding the spool and reel together so the inner reel doesnt move, push one of the cut strings through the eyehole in the side of the outer spool, and it should come up to the right, through a slot next to a small round hole the diameter of the string..if it doesnt, it just missed the exit (as i call it)..pull out and try again..let about an inch come thru..now take that end of the string and push the line into the little round hole until it stops, which should be about a little more than 1/8 of an inch..hold it in while pulling the excess line outside the spool to keep it in place..now do the same with the other string for the other side..once you have both lines in place, turn the inner reel counter clock-wise to draw in both lines through the eyeholes of the outer spool..you may or may not get all of the line to wind in..not a problem..you will still have enough to do what you need to do..just cut off the rest..one problem you may or may not have that i do most of the tyme is that it gets hard to turn the inner reel..one solution is to bump the top of the 'bump knob' with your fist, then pull both strings at the same tyme, then continue to turn..this method is quicker and easier than the second way of having the inner reel out and trying to wind both lines at the same tyme and trying to place the reel back in the spool..hope this works for you...
1,308 views
Usually answered in minutes!
how do i string my tb425cs trimmer?
Gastank removal and replacement on Troy-bilt string trimmer mobelTB90BC
string will not feed through holes
String will not go through hole and come out other side of hole. keeps getting stuck
I am trying to replace an old bump head on my Troy Bilt string trimmer (TB525 EC) but I can't get the old one off! I would like to see a diagram or picture showing me how, or DETAILED instructions. Other directions I have looked at online mention inserting a locking key, nail, Allen wrenches, etc. into a hole, but I can't locate that hole!
×