Rvm1335bc001 hood lights are on, no power to oven, no internal light, buttons don't react

The owner's manual is here. Be sure you have the clock set correctly.

You can also try a hard reset by unplugging the oven for a couple of minutes, plugging it back in, resetting the clock, and trying again.

Hi,
Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven....

Microwave Oven Basic Troubleshooting Tips

heatman101 [
][\=-

dont be a puss just use the thing

you will need the magnetron replaced $150-$180 price range part and labor

We see (and repair) this a lot. The problem is on the control panel, which we regularly repair nationwide by mail for $39.95 postpaid in about a week or so.

This light failure often occurs when a bulb goes out and the filament shorts, or when the bulbs are removed or installed without first unplugging the oven from the power line. Either can cause such a failure on the controller.

This can often also affect the exhaust fan, cooling fan, turntable, and/or inside light operation, too.

Details of our service are at our Web site, along with a video showing how to remove a typical over the range control panel assembly in under 5 minutes.

Feel free to contact me directly with your brand, full model number and symptoms.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

William E. Miller
[email protected]
http://www.microwavedisplay.com

Open the Micro door, and remove the air/Vent cover on the top if there is one, Usualy 2 screws on top or the middle of the cover.
Remove the screw holding the Controller board and then you will have access to the door switches 2-3 of them depending on Manif.

Also make sure you have the power unpluged befoe you do any of this.

Good luck!

I’m happy to help further over the phone at https://www.6ya.com/expert/michael_341f3f9dee622e54

I had the same problem! I was soooo frustrated! But, when my brother came to town, he took off the grill on the top of the micro hood, took out a few more screws, a plastic screen, another screw in the metal cover for the light and then reached in with his fingers to pull out the light bulb, we replaced it, then re-assembled it. It did take us about 30 minutes to do the job and you will need a phillips screwdriver, and a phillips screwdriver drill bit thing, but we were able to do it. I love having the light in the microhood again.

The problem lies in the circuit board / control panel. We regularly repair these control panel assemblies nationwide for 32.50.

The problem is damage to the control circuit board. This damage happens usually when the lamps are removed or installed without disconnecting the oven from the power line first. We regularly repair these boards for this very problem for customers from across the country for $32.50. We have an important file called "safety.txt" which you can find by a search on Yahoo.com. It's important information to consider before proceeding.

The problem is damage to the control circuit board. This damage happens usually when the lamps are removed or installed without disconnecting the oven from the power line first. We regularly repair these boards for this very problem for customers from across the country for $32.50. We have an important file called "safety.txt" which you can find by a doing a search for "microwave safety.txt" on Yahoo.com. It's important information to consider before proceeding.