Copier AR-M205 power error

fuser is not heated up.Check the fuser unit for broken element or open thermistor.Check the power supply

hello,
F2 04 Improper cartridge (destination error, life cycle error).
Try to put back the old cartridge , see if F2 dissapears, or try to put in a new one.
the toner cartridge seems to be the problem.

regards,
Adi

Yes it can.You should use a server and connect your computers to it and use your copier as printer.

MEASURES AGAINST E1-00 TROUBLE AFTER POWER ON
GENERAL: In very rare cases, E1-00 IMC communication trouble may be experienced when first
powering on the main copier unit
ACTION: To prevent E1-00 trouble when first powering on the copier, the following measures have
been taken:-
1. Resistor R26 (VRS-CZ1JD103J) mounted on the IMC2 PWB has been removed.
2. Capacitor C59 (0.01μF - VCKYCZ1CB103K) mounted on the IMC2 PWB has been
changed to a 1kJ resistor (VRSRCZ1JD102J, Location No. C59).
Note: Even if the part code for the IMC2 PWB is old, the above countermeasures have
been implemented when the mark "?" is applied to the upper right of the last 2
digits of the part code (as shown below):-

paper must have got stuck

Hello sir; "L6" display it means laser motor defect need to replace.

hi..there is a problem in the thermistor,thats why you
get the error code as H2.
check this out..
thank u..
kindly rate my response..

If subcode is 00 then network connection is problem, if 02, then its not talking to the network scanner tool on the computer. Might be an IP address problem, where the address in the webpage of copier is wrong for the PC.

Hello sir; this error code require reset the procedure as follow;
1, press "#", "interrupt", "clear", "interrupt".
2, enter 14, press start.
3, turn power off and back on

I really need to get my CD case out to make sure the code is the polygon motor, not a good sign, could need a new laser assbly.