Programme selector not working properly and unable to activate the dishwasher cycle
On off button works, When you switch on, you can select a programme, but when you close dishwasher door , after a couple of seconds there is a bleep but the cycle doesn't start. When you open the dishwasher door again the same programme is lit up, but it is stuck on this until you turn off the power and switch on again.
Lets try the following hope this works
1.- unplug the appliance, isolate it from the electric supply.
2.- Remove the kitchen unit plinth and check inside the inspection panels below the door to see if there is water in the base.
If there is, sponge it out and then try the machine again.
Was this helpful?
1,988 views
Usually answered in minutes!
My kenwood kdw60x10 dishwasher on button does not always work? If you shake the unit it then works? The switch is in the door
Programme cycle buttons not working
×