I need pedsteal brackets for my Lg washer

Hi Wendy:
I have found that Home Depot have been excellent at trying to ensure customer satisfaction.
My recommendation to you is that since this is a very recent purchase, you contact Home Depot. Customer Service Department as soon as possible. Request and record the name of the person that you are talking to, explain the problem, and ask how they can correct it. If there is not a simple fix, they will usually promptly replace a defective item.
Cheers.

Go back to home depot and see if they can take one from a display

it has a hot water element that can burn out
have it checked by an electrician or technician

how many times did you prime it & also what fuel oil mixture are you using 40:1 or 50:1

lowes or home depot carry some good ones

Buy a drill and drill bit and make a hole in the bracket where needed. To make installation easier, use a larger that needed drill bit and add washer to screw, won't look as professional but you are not a professional anyway. Who goes around looking at ceiling fan mounts anyway???

Unfortunately this problem can occur with all front loaders made by any manufacturer. The problem results from excessive soap and body oils that do not fully dissolve and/or rinse clean from inside the inner and out tubs. Front loaders are energy efficient and only use a little water so any build up between the tubs that gets higher than the water level is left behind. It is also natural that some moisture collects between the folds of the door gasket and, if not wiped out, will mildew over time.

Not to worry, a few changes in use (as compared to top load washers) can easily eliminate your current problem and keep it from returning.

First of all, make sure to ONLY use HE (high efficiency) detergent and make sure to use no more than 2-3 tablespoons per load (because too much detergent will cause oversudsing, not break down efficiently and build up between the inner and outer tubs).

To eliminate the problem you now have I highly recommend a product called Whirlout (available at Home Depot in the hot tubs section). Just one capful in an empty load with the hottest water cylce will break down the current build up and take care of any odors (a 2nd cycle if the problem is really bad).

To avoid any problems in the future, use the correct amount and type of HE detergent, wipe the door gasket dry when done with the laundry (for the day, week or however you do your laundry) and run an empty cycle once a month with a capful of Whirlout. If your machine is in a high humidity location (i.e. a basement), then leave the washer door cracked open when not in use.

Hope this helps, please rate my answer.

Thanks for responding. It is a EWave KOT-152UW. I think EWave is part of Magic Chef. I think it is the door switch. When I opened the microwave, the circuit breaker tripped. I reset the circuit breaker, and it worked for several days, but the last time, the microwave went dead. The reason I want to use the same bracket is it has through the wall (horizontal) venting to the outside, and I am not keen on trying to cut more holes.

HI MBAYSDELL,

HAPPY TO HELP YOU
OKAY, YOU NEED TO CALL LG NOT HOME DEPOT AND TELL THEM THE PROBLEM WAS FROM DAY ONE AND HOME DEPOT WAS NO HELP REFUSED TO DO ANY THING!
WHY DIDN'T YOU DO THIS RIGHT AWAY?

IN MANY FRONT LOADER WASHERS THERE IS A COUNTER WEIGHT BALANCED AT THE FACTORY.
yHE DELIVERY GUYS SHOULD KNOW NOT TO TILT THE MACHINE OVER TO MUCH , AND NOT TO LAY IT IN ANY POSITION BUT STANDING STRAIGHT UP!
THE MAYTAG NEPTUNE HAD THIS IN IT TOO!
GET LG ON THE PHONE AND ASK FOR A SUPERVISOR !
TELL HIM WHAT IS WRONG AND FOR HOW LONG!
TELL HIM YOU ARE READY TO REMODEL YOUR KITCHEN FOR $50,000 NEXT MONTH AND HAVE AL LG MAJOR APPLIANCES PICKED OUT!
HELP ME PLEASE OR MY WIFE WILL SAY THE HELL WITH LG AND MAKE ME BUY THE OTHER BRAND,JENAIR!!!!

WE SELL APPLIANCES FOR 65 YEARS IN NJ.
DO THIS NICELY AND CALMLY AND THEY WILL FIX OR REPLACE IT!
NEIL

PS. PLEASE GIVE ME A "PROBLEM SOLVED" RATING HERE ON FIXYA.COM
THANK YOU
NEIL

i used to do warranty work for LG needless to say, after finding out customers were waiting up to 2 1/2 months just to get parts i stopped doing any work for them. if it were me, i would take both the washer and dryer back and buy a bosch instead. much more reliable and there customer service is great