Where is the hole for the charger - Electrolux EL1022A Ergorapido 2-in-1 Stick / Hand Vacuum

Check distributor hc leads are in correct firing order for 4piston engine it is usually 1432 also check spark plugs haven't come loose this could be the problem if deisel check injectors for blockage and glowplugs are good

I am having the same issue. I've just replaced the filter and it started leaking out of this hole, where it never had before.
I am thinking that maybe the filter isn't seated properly, and that's causing the leak. But I have attached a picture of the hole in question. Any advice would be helpful. Thanks!

If the plug in charger works, the batteries are boiled out and need replacement.

They should not be left on charger all the time. Just charge them for 10 hours and use them until the performance has dropped off, then and only then put it back on charge for 10 hours.

Pull off the front panel and look at the upper right, you will see two holes. One on top is the size of a pencil, and one below it the size of a dime. Use a paperclip, pen tip, ect and push the reset button in the center of the dime sized hole.

you can, however the heat from the condenser will recirculate back into the evaporator, you need a place to discharge the hot air, and also the drainage from the condensate. I have cut holes in walls to the outside of the room in many applications with no windows, and they work fine. Just a matter of if you have an outside wall, and how much troble it is to cut the hole, frame the inside of the hole out, get power to the unit and secure the unit in the hole. Hope this helps...

What is the complete model number of the unit?
Two types of a 422 popped up on their website.

(from the manual) Turn off the unit. Look just below the last light on the "filter change indicater meter". You'll see a very small hole and the words "reset". Use a sharp object, such as the end of a paper clip (opened up) and stick the paper clip or sharp object into the hole. This is suppose to reset the unit. However, I have heard of cases when people of done what I just described but the indicator late still will not reside to green. I hope this helps you.

After spending hours searching for this supposed little hole easy to miss, I called customer service. I found out that it's easy to miss because it doesn't exist!

Here's the correct answer: Once you've replaced the filters, turn the unit back on. Then, with the machine running, press and hold down the on/off power button for about two seconds. The red light will flash and then turn off.

Noggin's solution is correct.  My copy of the BAP825 manual says to poke a paper clip into "the hole marked RESET."  There is no hole marked 'reset' on the air cleaner.  Thanks, Noggin!