Dfl-1600 sytem restart

Re install operating system

Hi,
i have the same problem!!! have you fixed it? How?

Thx
F.

Hi there
You can try see if this may do it.

Go to Start / Run and type in "services.msc" without quotation marks, then press Enter or click OK.

In the window that opens (Services) look for "Print Spooler" on the right

Right-click "Print Spooler" and select "Properties".

Click on the "Recovery" tab and change all 3 drop-down boxes to "Restart The Service".

Make sure the 2 text boxes underneath say "1" in them.

Click Ok until you are back at the Services window, close it and you're good to go.

Go back into the properties of the "Print Spooler" tab and be sure to click Start to restart the Print Spooler service and it will restart the service immediately.

The Print spooler depends on the Remote Procedure Call (RPC) service. Is this service disabled? Go to services.msc look for RPC. Check state: Automatic

Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks

upon turning on the power hit f8 and then select safe mode with networking. once windows is up go to start>all programs>accessories>sytem tools and select system restore on system restore select a date before you installed IE8.Let it process and you should be good to go.

If you can get into your bios settings make sure your boot order is cd 1st. Make sure you have OS cd in drive when you restart system. You will be given the option to repair windows or install fresh. Good Luck.

connect your router to computer with ethenret cable in lan port.
Then access your router with following link.
http://192.168.1.1
or
http://192.168.0.1
type user name as "admin" and password as "admin" or blank or 'password"

then go to advanced and enable dhcp then save settings and restart the router to take effect.

you should be able to administrate the router by browsing to your default gateway address. then you disable the firewall in the router admin software

With the unit on, locate the small reset switch on the back of the router. Insert the end of a paperclip into the reset switch and hold for 10 seconds. The router will restart itself and the WLAN light will stop blinking.  The router is now reset to factory defaults. 

Remember The factory defaults username is admin, and there is no password.

check all cables ide connectors .the problem may lie in the processor loose hsf or broken pins.if not irregular power supply .

I would suggest making a few changes at a time, if you haven't already I would update to the latest firmware, 2.11.02. I don't remember having that problem when I initially set mine up but it has been awhile.