Setting tempture whitch way to turn dial to get colder up or down. 5-1 or6-10 currentlyv set at 5.

Sounds like your thermostat is bad. You probably have to replace it and the sending unit also. Big job! Look for a manual at : http://www.servicemanuals.net

Turn temp control to the off position.You can only turn it on one way.That way is colder.Set it one half way

Hi Normally temperature dial has at left maximum temperature while right is minimum temperature.
You can feel ( hear ) actually the sound of motor/compressor when it is run. Running motor will produce low temperature. By this you can decide where the set point should be made

The freezer should be set at 4 or 5 to start. If that is not cold enough then move the temp knob to 6 or 7 to get it colder. the higher the # the colder it will get. Onse you set the new temp it will take around 4 hrs to get to the new setting.

Good Luck and please rate 4 thumbs up for the free answer.

The higher the number (0-6) the colder the box. Hope this helps

usually the higher the number the colder it gets. Easiest way to tell on all models is the number closest to off is the warmest setting... Eric

Begin by turning the freezer temperature control dial to a colder setting and see if this solves your problem.

Turning it to the right will make it colder. It will only regulate the temp. by few degrees, so if your thinking there will be a big change there won't be.

The higher the number, the colder.

I have a danby mini fridge and freezer and noticed the same problem. The temperature dial has NO NUMBERS ON IT! it just has a strip that goes from light to dark blue. That's it. I looked in the manual and it doesn't say anywhere which way is colder...it makes sense that the darker the blue the colder the temperature but why keep us guessing?