Can a turner ssb+2 micraphone be wired to a ranger 2995dx cb radio?

Hello, We need the model # of the radio to tell you any info but here is the link to the Turner wiring manual. Sears radios are on pg. 21.

http://www.cbtricks.com/mic_manuals/turner/turner_mic_wiring_book.pdf

the best i can find is this
red pin 5 ptt
black pin 4 ptt ground
white pin 1 mic
shield pin 2 mic ground
no connection pic 3

where is put the wire black and yellow inside.

www.cbtricks.com

Turner
1-Shield & Red
2-White
3-Blue
4-Black
Yellow NC
Road King standard 4 pin wiring Gallaxy/ranger/cobra..............Magnum
I have no info on the 5 pin as i know the OmegaForce version has an addition mic plug, i figure yours might also.

hi the easiest solution i find is to keep the ptt pressed remove wires from connector ,then place connector in radio try two wires at a time you will finally get the transmit wires then all you need is the audio ,you can flick over to ssb to sort the audio hope this helps you goodluck

Ranger Parts and Service is in California. (760) 440-0125

ITS JUST NOT THE TURNER MIC IT HAPPENS WITH ALL BASE MICS HAVE HAD THE SAME PROBLEM WITH MY 2995DX WITH A ASTATIC D-104 & 1104-C AND ALSO ANY TURNER I HAVE USED BUT I CAN RUN A ASTATIC MOBILE D-104M6B OR RED DEVIL AND NO SQUEAL HAVE YOU TRIED GROUNDING THE CASE OF THE RADIO IT IS RF FEED BACK SQUEAL SO MY SUGGESTION TO YOU IS TO RUN A 48 COPPER GROUND ROD INTO THE GROUND AND RUN A NICE GROUND WIRE TO THE BACK OR THE CHASIS OF THE RADIO AND IF YOU ARE USING ANY EXTERNAL AMPLIFIERS ALSO GROUND THEM AND YOUR SQUEAL WILL BE ILLMINATED

check tr 51 (Q 51) the sb754 on the back side mounting of the radio.. the center pin (collector) of this modulator ic should not be 13 volts. my bet is that it is.. this test is done in am mode.. not sideband.
depending on you carrier setiing it should be between 3 -8 volts any higher in am mode and my bet is that its bad... much more common than the finals in this radio. good luck Rick

Hello janetsue, If this radio has the blue or green screen LCD face then this is a default that is built into the radio. It depends on how the radio was "converted" when it was bought new.
It will not key up on 10 or 12 because of the default. A little more info supplied would be real helpful,,,, Let me know, Mechanic