Slimline bosch dishwasher

Replace the defective cycle timer

Hi Kathleen,

Welcome to Fixya, you came to the right place.

I`m not sure what model you have, but typically you should be able to select another cycle by choosing a button and pressing it twice quickly.

For instance if you want`"normal" press the normal button twice in 2-4 seconds and it should go to normal cycle.

Let me know how you make out. Good luck and thanks for visiting "fixya".

Please take moment and rate this solution favorable if indeed it helped you, if not let me know and we`ll move forward from here.

macmarkus :)

check rinse aid levels a lack of it will effect drying badly.

remove the water and, the burnt plastic that probanly melted on the dish drying heater coil
close and, lock the door turn the dishwasher back on and, reset the circuit breaker to see if the motor will run or, is damaged

Are you using drying agent?If not you have to use it in bosch dishwashers.When the cycle is completed is it hot,steam rolls out.if not you have a heater problem or thermostat problem.
If you need more info please ask

no not if it getting hot it still sounds like the motor isnt coming on put the spray arms in the same position turn it on then open the door are the arms still in the same position or haved the moved.those cleaners need hot moving water to melt the seal.

It could be a sensor or timer solenoid in the dishwasher maybe broken and needs replacing.
http://www.repairclinic.com/bosch-dishwasher-parts-gg.htm

Just bought a Bosch dishwasher and we were told that they have no heating mechanism to dry the dishes, which is why they are more energy efficient.  You are supposed to leave the door closed for at least one hour after the cycle is complete.  The heat that has built up inside during the wash cycle will dry the dishes.  It is also recommended to always use JetDry. If you follow this advice, the dishes will come out fine.

the problem is the circulation motor needs to be loosen up take a 5'16 driver open the filter on the bottom and loosen it at froom thr small hole on the left.

fault is that there is a leak. the tray at base of dishwasher is full of water which operates a float and turns on drain pump. tilt over 45deg and water will run out and then it will work or remove bottom front panel and mop out (better). then find leak