Onkyo HT-S770 Home Theater System

"Grave" reviews??

If you set it up as specified in the manual it will be optimized. As far as volume settings while listening go, that is subjective and entirely up to you, your speakers and your neighors.

Register and download the manual for free at retrevo.com

http://www.retrevo.com/support/Onkyo-HT-S5300-Home-Theater-Systems-manual/id/23655bh932/t/2/

i did a factory reset on mine. it had the classic problems. no sound from any input except the tape input. after i did a factory reset they all seem to work.. we shall see for how long...

You should be able to find out here --

---> http://www.accessories4less.com/make-a-store/category/HTIB/Home-Audio/Packaged-Systems/1.html?gclid=CIC9_7i01ZsCFQJSxwodIhfEmQ

Hope this helps !!
rate me good ;o)

It's possible that you have the wrong speaker set (A or B). Look for that button and change the setting and see if that works

You will either have to use your Onkyo remote to teach the Harmony those functions or try one of the similar model receivers in the Harmony software. I had to chose a similar DVD player in the list in order to get my Harmony to play nice with my DVD player.

if you are using an HDMI cable dont expect sound to come out (even thought HDMI carries both audio and video) the onkyo HT-s5100's Receiver is the HT-r560. the 500 models of the onkyo receiver does not allow HDMI to carry both audio and video. it only allows the video signal to pass to the receiver.

if youre using optical for audio w/c is what you need then these are the steps you need to follow.
*first make sure that the optical connections are ok at the back of the receiver.
*make sure that your DIGITAL INPUT is set to either OPT1 or OPT2 whichever optical input you used to connect the optical cable.
*then go to your PS# settings : go to sound settings / audio moutput settings/ select digital out (optical).

then enjoy.....ü

I had the same problem too. All functions seemed operational but I could not get any sound out of my unit. I took my HT-R520 (4yr Old) to the Onkyo Service center in Denver Colorado (DTS). I paid out $50.00 to have them diagnois the problem. I was hoping that they would listen to me and the info I found via fixya user jaf323 and fix the problem for $50.00. Not....they ignored me. They told me it was my power supply and it would be $250.00 to fix the problem. Sooo, I decided investigate the problem myself. After finding an Okyo schematic free online for the 600 model which is similiar to the HT-R520, I was able to find the L7002 coil. I took my DVM to all of the coils I could get to labled 2R2 on the large horizontal PWA on the right side of the unit as you look at the front panel and sure enough, the L7002 coil was "open". All of the other coils (approx 4) showed a resistance of about 0.3MOhm. I pulled off the bad coil and swapped it out with same coil marked 2R2 from the headphone PWA using a tweezer soldering iron. I am a novice when it comes to electronics. This was a simple fix. BTW the little coils are about 1/8" x1/8" - little guys.

Hello the HT-R520 is the model of the receiver that is part of the HT-S770 package. I suggest that you check the speaker settings. Check the level of the center speaker. If you need assistance please contact Onkyo at 800-229-1687 option #3. Thank you, Onkyo USA

You can find manuals for Onkyo products here http://www.onkyousa.com/download/own_manuals.cfm