Controls remote control

If you wish to buy its original remote control, contact the authorized service centre, or authorized dealer to your device brand. They can either give you a genuine remote control to your device, or can direct you, from where can you purchase a suitable one.
To select a proper universal remote control, you should know about the number of digits to its set-up codes. There are 3 digit, 4 digit, 5 digit, 2 digit and even single digit codes, to some brand devices. After confirming this, check the sites linked here. Both the sites have set-up code list and set-up procedure to many popular brand remote controls. Check which brand remote control has set-up code/s to your device brand, and buy that one according to availability? Brand name of the remote control isn't a matter, but it should have set-up codes in its code list, to the device brand you have.
Please note: Every new universal remote control will have set-up code list, and set-up procedure along with its pack. Never accept a remote control, that hasn't both of this. For more details about the set-up codes, visit the site http://electrohelponline.blogspot.com/ Check this site too. http://remotesearch.blogspot.com/ Universal remote controls are available at most of the electronic spare part selling shops.

Try this link to download it.

Hello
Vizio TV has not listed with any of Big Button remote control setup codes. OK.

Manual Programming

1. Turn on the device with which you want to use the remote control.

2. Locate a 3-digit code for your device. Refer to the the below codes

3. Press and hold the corresponding button on the remote control (TV, VCR, SAT, DVD, CAB or AUD) for approximately three seconds. The POWER INDICATOR illuminates.

4. Enter the 3-digit code for your device within 30 seconds. The POWER INDICATOR shuts off.

5. Press to verify correct code entry. If the device shuts off, the code was entered correctly. If the device does not shut off, repeat steps 3-4, using a different code located below

Sony 002, 018, 026, 098, 100, 121, 123, 134

If you go to the following website:

http://www.sentryindustries.com/category/remotes/remotes_rmc10.asp

You'll see a link just to the left of the picture of the remote to download the codes for the remote. That should give you all of the information you were looking for.

how to program the technika tr41r remote control

http://resources.jvc.com/Resources/00/00/99/82841ien.pdf

THE NEW REMOTE MAY NOT BE THE CORRECT SYSTEM FOR THE UNIT YOU HAVE.
THE ONE THAT DOESN'T WORK MOST LIKELY NEEDS A NEW BATTERY.
NOTE IT MUST BE REPROGRAMED AFTER CHANGING THE BATTERY

HOPE THIS HELPS

Buy a universal remote.
or
If there is no input button on the remote or TV, try the channels between 90-110, some RCA TVs have the A/V in there somewhere.
http://www.ecoustics.com/electronics/forum/home-video/134340.html