What model? Connector on the outside or on the mainboard? If on the mainboard, replace it. If on the front, you should be able to just replace the connector cable and/or mounting.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
first confirm it that u hv pull out the strip from the tooner
second the tooner sitted properly pls check the grounding connectors touches the tooner properly.
third one the suttor of scaner *** not open properly call hp engr for this problem.
If you have the green light and test prints OK, check the condition of the USB connector in the back of the printer. The pins inside get damaged by being too close to the wall or something like that, broken connections to the logic pcb, You can solder a new connector on if that's the problem, otherwise you may need a new circuit board.
thats very simple friend, just go back to your system and search for a flat connector called usb with a symbol to make you identify it on the cable of the scanner and on the back of the system
has it complete broken from the printer or is it partially attached? I would imagine that a new connector could be resoldered onto the board, but it might be a bit difficult. You could try contacting HP about this issue. They might be able to repair it or sell you a refurb unit for cheap.
×