Hava a Whirlpool Generation 2000+ wall oven (model no; G2p 90F/WH). Error F03 is shown on display. Looking on the net this fault appeared to relate to the oven temperature sensor (thermistor). I replaced this part, but still have F03 on the oven. I'm thinking the main control pcb is at fault. Before I splash out on a new part can anyone confirm this is the fault for sure?
F03 error is a sensor error.you could have taken an ohm reading on the thermistor to see if it was bad.if you replaces the t-mistor then the only other component responsible is the board.make sure all the connections on the board are clean and tight before you replace it.
Where to check the termistor ?
I got f03 error 2 min after booting the oven:
http://www.fixya.com/support/t27082170-whirlpool_oven_akz430_goes_f03_mode_in#
8,348 views
Usually answered in minutes!
We have a Whirlpool oven model no. OBI C10 purchased from Ikea. It has fault F03 on the display. Is this a part that can be purchased and installed by ourselves? Or do I have to get a Whirlpool engineer out and pay £79 call-out charge for his services, plus cost of part? Is it possible to get the part?
I have got the same problem. My oven is showing error message F 03 and dont know what to do with it? Do I need proffesional out to get it fixed or can i do it myself?
I have the same problem ,my mod: is akz493-1x it show's eror of FO3 problem .so how can i fix that ? do i need proffetional
oven wont work and is sayin f 03 HELP !!!!!!!!!!!!!!!!
oven shuts down with error f03 appears
How long does it stays up before F03 ?http://www.fixya.com/support/t27082170-w...
×