Return factory specs reset - Rotel Rsp-1068

To factory reset a router, there should be a reset button on the back of the unit near the power button. Usually you can press and hold this with a pen or pencil (or bent paperclip point) while the unit is plugged in, then unplug the router while holding the reset button down and power it back on. Do this for about 5-10 seconds and it should return it to factory spec.

Yes, that will make it so that the software will return to the factory state. If not then you'll have to either follow the prompts through the phone menus or boot mode to initiate a factory data reset.

Go to the NetGear device and pull the power plug out, look for the rest pin (the small port) and push a paper clip into the port. Hold it down and reattach the power line. Hold for 10 seconds. This should return the device to Factory specs. Resinsall the software you were provided with and came in the box. Start over and go from there.

The only thing you can do is reset the phone to factory specs, unfortunately, you'll lose your data if not already backed up. Follow this procedure:

What does a Hard Reset do and how is it performed?

A hard reset removes all information from your device and returns it to a state just like it has never been used before. All contacts, messages, emails, 3rd party applications, etc. will need to be reinstalled after performing a hard reset. To perform a hard reset, from the Home screen tap Menu > Settings > SD & phone storage > Factory data reset. Follow the on-screen prompts to complete. This process will take 5-10 minutes

src: http://www.htc.com/us/support/t-mobile-mytouch-4g/help/general-and-other

if this is the SYNET07526:
Did you try the reset button on the back? about 1in. diagonally from the right lower corner of the data plate. insert a tooth pick in the little hole and hold for about ten seconds with the power plugged in. This should reset it to the factory specs.

If that does not work then you may have to flash the system. If you decide to do this, see my TIP at:

: http://www.fixya.com/support/r7350901-fix_synet07526_wifi_flashing

The only way is to hard reset the phone. That will erase all your data and it will return back to factory specs.
http://www.technipages.com/hard-reset-motorola-cliq.html

Hard reset to return the phone to factory specs. Search manufacturer website or ask your service provider.

Hi,

how to reset the Curve back to factory state (a complete wipe-out). Please note if you just want to reboot the device, you only need to take out the battery.

To reset the phone back to factory state:
Go to Options -> Security Options -> General Settings
Press the BlackBerry Menu key and select "Wipe Handheld" and type in "blackberry"

Thanks.

A Hard Reset wipes the internal memory and returns the Treo to its factory specs, in effect returning the Treo 750 to the state it was in when you purchased it. All data entered, preferences set or software installed on the Treo after purchase will be lost after a hard reset and will have to transferred or reinstalled via ActiveSync / Windows Mobile Device Center.
The Palm Treo 750 can be hard reset by pressing and holding the power button (seen left) while at the same time pressing and holding reset button beneath the miniSD memory card door. Press and hold the two buttons until the screen completely fades. When the screen returns, you'll be given the option to "Erase all data." Select Yes to complete the hard reset.
The Treo will now be as it was when it left the factory and you can start fresh. You may have to perform a soft reset after the hard reset to get the unit to power on.

Enter the SETUP menu and select RESET. You'll be prompted to reset two sections. Answer YES to both and everything that can be set to default will go back to the factory default state.