30A LOAD CENTER Square D Co Model: QO2L30SCP

https://blog.bavauto.com/5677/bmw-e46-3-series-engine-electronics-fuse-pack-in-underhood-e-box/

Fuse 1 - 30A - DME, Injectors, SMG Hydraulic unit
Fuse 2 - 30A - DME, Idle control valve, Fuel tank ventilation valve, Fuel pump
Fuse 3 - 20A - E-box fan, Transmission RPM sensor, Camshaft positioning sensors, Mass airflow sensor, Fuel pump relay, Secondary air pump relay, A/C Compressor relay, Fuel tank leakage diagnostic module, SMG selector lever
Fuse 4 - 30A - Oxygen sensors and oxygen sensor heater circuits.
Fuse 5 - 30A - Fuel injector relay.

Jack First, Numrich Arms and the Gun Parts Co all have parts drawings but guns didn't come with manuals and break downs until after WW-II.

Make sure there aren't any loose contacts or shorts in the wiring or in any of your appliances.

This could also be because of extremely high load. What all devices are hooked onto that line and run simultaneously?

The square root sign looks like ? or the same sign with the end elongated as a horizontal line.
On TI-30A, this is left to the division button. the sign is with an x inside it. (This denotes square root of x).

I prefer Square D panels. They have been easier to install than others in my experience. When you say you have 2 30s that are joined you mean you have wires piggybacked together on the breaker? or a tandem 30?

That number in the heading is not correct. While you might find a breaker that "fits" your panel there is no other brand that is listed to work with your panel The correct number would be

HOM115GFICP If you can't find it locally, there are many locations you can order one from online. I don't know where you are locatged, but an electrical supply house or even homedepot should have one.

AC/DC Adapter
Model MA-9200
Input 120 VAC 60 Hz
Output 9 VAC 200 Ma
Class 2 Transformer

The agitator comes off by following these simple steps:

1. Remove the agitator center cap or fabric softener dispenser (if equipped) by either pulling straight up or gently placing a flat blade screwdriver into a slot located in the cap.

2. If the agitator is equipped with an inner cap with a handle, remove this as well by pulling straight up.

3. Remove the center bolt of the agitator. You will have either a 7/16” hex bolt or a recessed square plastic nut. If you have the square recessed type, use a 3/8” to ½” ratchet adapter to remove.

4. Remove the agitator by grasping the bottom flange and carefully pulling straight up. Try to keep all the parts assembled while doing this, so do not pull too hard. This will make this reassembly much easier.

If you need further assistance, please let me know. I hope this helps you.

The ground bar is tied directly to the box and the neutral bar is insulated from the box.

i need to download model VF 0220.