E01 F09 error - Maytag MHW6000XW - MaximaTM High-Efficiency Front Load Washer

https://www.northlondonappliancerepairs.co.uk/discussions/question/what-does-the-error-code-e01-f09-mean-on-my-whirlpool-duet-washing-machine.html

The F09 E01 error indicates a long drain on a Whirlpool washing machine. The pump couldn't remove the water in a timely fashion. Sometimes the solution is easy. Unplug the washing machine. Open the washing machine bottom panel (on the front) and have a bucket nearby. Remove the cap to the washing machine drain trap. Remove any debris that is in the trap. Use the bucket if any water drains out of the machine. Look past the trap to see if anything is blocking the impeller of the drain pump. If there is, try to remove the debris. If any of the blades are damaged, you probably will need to replace the pump.

Replace the cover of the drain trap. Make sure that no wires are loose and try getting the washer to drain again. If the long drain persists, check your drain hose and stand pipe for blockages. Clean out any problems. Check the pump and the wiring to the pump and replace any damaged parts.

The parts diagram for the tub and basket area is available here: https://www.appliancepartspros.com/tub-and-basket-parts-for-whirlpool-wfw87hedc0.html . (Note: this is one of several models.)

I hope this helps.

Cindy Wells

unplug the machine take the top off and push the drum to the rear and using a small screwdriver remove the door lock and replace it from the manufactures website spares department good luck eric

F09/E01 are related codes.

LONG DRAIN: If the drain time exceeds 8 minutes without reaching reset level in pressure sensor, the valves are turned off and the drain pump will stop running. NOTE: Suds can cause delays in draining. Washer drains for 4 minutes, pauses 5 minutes, then tries again for 4 additional minutes of draining. F9E1 will display if washer does not drain. (Normal drain takes less than 2 minutes)

Possible Causes:
Verify that the drain hose is not blocked or kinked.
Make sure drain hose is not sealed into drain pipe.
Make sure the drain hose height does not exceed 96" (2.4 m).
Check/clean drain pump filter of foreign objects.
Check connections from tub to air trap, air trap to pressure hose, and pressure hose to pressure sensor.
See TEST #8 (Drain Pump) on page 19. Is pressure hose pinched, kinked, plugged, or leaking air?Is pressure hose pinched, kinked, plugged, or leaking air?Is pressure hose pinched, kinked, plugged, or leaking air?
.

How To Fix Maytag Washer Error Code F9 E1 ...

www.appliancerepairlesson.com/2013/.../maytag-washer-error-code-f9-e...

Dec 10, 2013 - The error code F9 E1 will be displayed on most newer Maytag washers and ..... My whirlpool duet wfw94heaw0 gives the error code F09 E01.

KitchenAid f09 error code Dishwashers Questions ... - Fixya

Long drain something restricting water flow in drain cycle

First try holding down the cancel button for 10 seconds and releasing (might have to do this 2~3 times). The technician manual is located under the lower front panel. I've heard that locating the CCU (brain box, in lower right) freeing it up and giving it a couple of wacks has worked. F09 is pressure switch, E01 is Thermistor. The tech manual will be a great help!!

Did you clean the tube that goes from the tub to the drain filter then the drain pump it is behind the front panel also make sure there is nothing in the drain pump stopping the impeller from turning.