Connect the front channels out from the radio to the main in on the eq.
I’m happy to help further over the phone at https://www.6ya.com/expert/chris_7f7f91eb941fb23f
SOURCE: wiring
The B.reny connects up to an ALWAYS on power source in your car, like right to the battery or a terminal in your fuse panel that is always on even if the key is off, and the acc hooks up to a swiched power sourch, like where the original radio was connected, as the acc is called the memory wire. good Luck
SOURCE: I am trying to install
CLICK HERE for your Owners manual in PDF format
CLICK HERE for your Installation Guide in PDF format
As we agreed in chat - you are going to run your 4 channel amplifier as follows...
Front Channels of amplifier will run left and right independently.
Wire up the left speakers in parallel all + together and all - together.
This will yield a 2 Ohm load.
To the Same with the Right Side speakers - on the FRONT Right channel of the amplifier.
Now you have a 2ohm stereo load on the FRONT channels of your amplifier.
And using the BRIDGED nomenclature on the REAR channels of your amplifier - wire up your 4ohm sub mono.
Here is a crude drawing for a visual
Thanks for using FixYa - a 4 THUMB rating is appreciated.
264 views
Usually answered in minutes!
×