Battery Error Code:2000-0133 - Dell Inspiron 9100 Notebook

Did you get the car plugged into a diagnostic reader after the battery change?
Some newer car ECU's need to be reset to 'new battery' settings. Over time the system alters the battery charge rate as the battery gets older and weaker so a new battery will overcharge if not reset..
The error code, (P0563), reads as "system voltage high".
Get the car plugged into a good diagnostic system and that will allow you to correct the error code and battery settings.
The other symptoms may settle down once the error code is sorted out.

battery error code
2000-0132 error indicates the battery is reaching the end of its usable life. Please remove and re seat the battery on the system and rerun the dell diagnostics on the system.
try another battery

Hello,
The error code P1500 means there was a problem "Alternator FR teminal circuit"

Was the battery jump started recently or battery gone dead? This code condition tends to be intermittent especially when a jump start was given

Remove the bottom cover of the laptop. The CMOS battery is a disc 3.2 volt li-on battery. replace it with the same voltage and size battery.

Error code 161 means your CMOS battery is dead and 163 is that system date and time are not set (which make sense as the CMOS battery is dead).
You need to replaced your CMOS motherboard battery to resolved this issue.

hi,

The "E50" error code indicates formatting a storage card has failed.I think the e50 error code happens when the camera is reading and/or writing to the CF card when the battery are dead or real low. The camera does not get to finish writing data and leaves an error on the CF card. Use new battery or fully charged battery. I hope this may help you,

regards,
kaybicks

Error code Number P1684 Battery Disconnected Within Last 50 Starts. Check battery and connections.

Sony says the unit needs a power reset (error 31). Unplug the camera, remove the battery and wait several minutes before re-attaching the battery and/or AC cable. Then power the camera back up. The 23 code says you need to use a InfoLithium battery-- apparently these are smart batteries that give data back to the camera. These error codes seem to be quite common however, and so a hardware issue may be the case. Some users have said that removing the battery while the camera is powered on will clear the codes. Others advocate "smacking" the camera, I would not however, recommend this. www.sony.com is a good place to look for more information.