Control problems wl toys v912 heli - Jumbo RC JUMBO HELICOPTER

v912 what in the world is that, we can't guess it?
a toy helicopter?
IDK< not one hint.
join there forum ? makers, not fixya.

my guess is the batteries are dead, discharged or weak etc.
on cheap toys recharging takes a long time, did you read the manual on how to do that first>? and how long it takes.

what stopped working, the heli, the charger or both.
test the battery yet?
crashing any toy flying machine is big risk to it,
things (vast) inside CRACK or get loose, inspections inside can work, did you.... best is to buy 2 and when one dies ,swap part to learn what Actually died.

guessing $80 copter.

Mode exchange: hold on the switch button and turn on the power switch "at the same time". Did you try this?
You can change rom modes 1, 2, 3 and 4.

Hang it from a sting attached to the rotor shaft and see if it hangs level. It sounds to me like it is off balance.

i think it has something to do with the signal to heli from transmitter

Yes, you need to buy an AnyLink transmetter that will plug in the trainer plug of your tranmitter.
I put a web link to Tactic anylink products that can be order from internet from online hobbyshop, look in the Where to buy tab on anylink website. Have fun :-)

Hi,
I have similar problem with my LS-208 heli.
Helicopter leds are blinking red/green, front white led is on, and tail leds are blinking too.
Remote controller red led is on as should be but helicopter doesn't respond to controller at all.
I followed instructions above with no success.
Anyone has a suggestion?
Regards, Yaron.

Have the same problem with my S107 heli. I determined it's in the speed control hooked to the gyro control. This control feature helps keep heli
from turning in flight caused from tork. The lower blades are the ones
that speed up slow down to keep heli orientated. I'm replacing the control board.

its ok dont worry just plug it in.

when you unplug the heli if the red light gets brighter its not done. when its as bright as when not plugged in its done.

or simply leave it an hour it will still work

This has happened to two of mine, fairly common problem if you keep hitting things with your back rotor.
Solution 1: Replace the tail assembly
Solution 2: Remove the canopy and put a small weight in the nose which will serve to drag your heli forward. No backward flight but it works better than a heli that just hovers.

Try setting the heli down on a table and with the transmitter behind the heli, turn the throttle up until the blades start spinning. If that doesn't work, then I don't know how to help you.