Screen comes up with up and down lines and thats all , hasen't been used in

There is no need to make a manual, have a look at the Computers For Dummies series of books.
Check out this WEB site.
http://www.amazon.co.uk/PCs-Dummies-For-Computers/dp/0764540742

There is no need to make a manual, have a look at the Computers For Dummies series of books.
Check out this WEB site.
http://www.amazon.co.uk/PCs-Dummies-For-Computers/dp/0764540742

diesel?
check the wire that runs to the injector pump hasen't come off.

Hello, Inside you fridge part (not the Freezer) you will find your cooling fins,and on you fins there is a white piese of plastic and in this plastic there is a probe this will adjust you temp. by slidding it up and down.but it hasen't been touched you may have a faulty probe.acesses to plug is in rear of fridge in a black box (printed circit board)located outside of camper,you may need a qualified person to install.

Hi trade4cma ,
Check your Panasonic to see if it hasen't been accidentally set to NTSC ( Configuration \ Connection \ System TV ) .
Best regards ,
fanaudi .

If the check engine light is on, there is a problem that the computer has detected and it needs to be fixed first. Once the proper repair(s) have been made you can use a code reader that has the ability to "reset" the light. You could also just disconnect the battery for 15 minutes. If the problem hasen't been fixed the light will come back on.

I would give them a call if it hasen't been shipped yet you will have a very good chance of cancelling.
Phone Nubers from there site. 0 1438 728 888 UK

+44 1438 728 888 EU

I must be missing something here, the question I am seeing uis as follows. (Its a 1990 Lazer RS have put new gas in it and a new battery, it hasen\'t been driven in 5-7 yrs. We rally need this car to run its all I have left to rezort too. Please help!) I don't see a question here. What is the issue. I can tell you that a car that has sat for that many years will need some attention before it will be a working car. The gas tank needs to be drained before trying to start, ot other wise the fuel pump in the tank will clogg with old varnished gasoline. There is a screen on the pump that will plug and you will not get any gas to flow though it, along with any filters you have in line will plug as well. Once these are plugged they will have to be changed before gas can flow.
Where are you at on this?

If you have spark, try changing the fuel filter. If you don't have spark, get back to me.

Boot the computer in BIOS and if you sill have lines than the LCD is leaking.

To boot to BIOS tap "F2" OR "F10", multiple times as soon as you hit the power button to turn on the computer/

Regards

Sammy