My computer just shuts down when the battery dies. How do i get a low battery warning to come up again because it doesn't.
Open Power Options by clicking the Start button, clicking Control Panel, clicking System and Security, and then clicking Power Options. On the Select a power plan page, next to the plan you want to change, click Change plan settings. On the Change settings for the plan page, click Change advanced power settings. On the Advanced settings tab, expand Battery, expand Low battery level, Reserve battery level, and Critical battery level. Change the percentage of battery remaining that you want for each level, and then click OK.
Testimonial: "I have it on already, but it still doesn't show up."
SOURCE: DELL D520 LAPTOP
Problem cause:
Do diagnose your Laptop try to change your battery or adapter if you have some backup device
SOURCE: while using my power cord, low battery warning
If the system is charging the battery while connected to the adapter and not running but runs off the battery when powers on, then you likely have an issue with the motherboard charging circuit.
See if you can flash the BIOS to the most current version. If no go, then replace the motherboard
SOURCE: Purchased a new Dell Inspiron 6000 (9 cell) battery
Have a look in your power properties and see the settings.They may be set at when battery reaches 30% The computer shutsdown. You can change the settings to your own preferance.
Engine stalls cold or RPM
fluctuates at idle up and down or dies near idle.
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.
335 views
Usually answered in minutes!
×