I have a kenmore sewing machine model #14812181, this machine has sewing with out any problems until now. forsome reason it started poping the bobbin and shuttle case out. I have checked the tensions and have cleaned and oiled the machine and I even replaced the needle.I checked the needle timing and reset a gap of 3/32 between the eye of the needle and the point of the shuttle. I am stumped please help if you know what the problem is. Thank You . Will [email protected]
You might need to clean the shuttle assembly.
1. Raise the needle bar to its highest position and remove the bobbin case.
2. Push levers sideways of the shuttle assembly and liftshuttle and shuttle race cove out by the center pin.
3. Clean the shuttle race of any lint or small particles of thread with a small brush.
4. Put a drop of oil on the center pin of the shuttle and on the shuttle race.
to reassemble, hold sjuttle by center pin and it carefull into assembly opposit the shuttle driver. Slip shuttle race cover into place. Snap the levers into position.
Occasionally remove the needle plate and clean feed dog with soft brush.
I hope that helps!
1,111 views
Usually answered in minutes!
×