Replacement wristband for Haurex Black Mamba watch

Ok--now what?

there will be a plastic tab behind the crown pull it out then push winder in

i just bought one last week and having the same problem. I have an accutron automatic watch and once i get it started it will keep time for up to 48 hours w/ no movement. I think the haurex is poorly made and if i can't get it to run longer than 12 hrs( wichi is about how long it runs now) i will be returning it.

It is unusual for a quartz watch to stop so soon (presumably the battery is now dead?).

I suggest you contact the makers local customer care center and discuss it with them.

You can find their local service center by going to http://www.haurex.com/collezione.asp?id=93 and clicking on "after sales service". If you have any proof of purchase date, then it should be still under warranty if it needs repair.

pull the small loop on the end of the metal clasp. place the other strap through the loop and snap closed. fold one end of the clasp shut then the other.

This is completely wrong. You HAVE to open watch's case back, remove the stem and then get whole movement out. Then you will be able to refit emblem. Rate me, plz.

Go back to the supplier; If you cannot get the clasp to work, you should be shown how to operate it (or it should be replaced if it is broken).

If you have a new wristband, there is a spring loaded lug where the band joins the watch, use a sharp knife or jeweler's screwdriver to slide the lug from the watch

CALLANEN INTERNATIONAL
ATTN: SERVICE CENTER
145 WOODWARD AVENUE
NORWALK, CT 06854
Phone: 1 800 248 3775 Fax: 1 203 855 0657