Korg Triton Le keyboard not working

Try this site:

http://www.tritonhaven.com/

For specialized hardware like this, it's best to contact the manufacturer directly.

refer the guide below
http://www.korg.com/uploads/Support/Ex_OperationGuide_E2_633667497932220000.pdf

There should be service center near your house.OR better u give us your location and about cost there is range in every in product it depend on u what suites u better

http://www.korg.com/uploads/Support/Le_BasicGuide_633667534609260000.pdf

try cleaning ALL the contacts involved with Caig DeOxit (D5, S5. F6, G5, etc.) products*, they work very well. e.g.; cables, inputs, outputs, and (if you're confident) all the contact points "under the hood". this static you speak of sounds like less than stellar contact points and can addressed at home if you've the motivation to DIY.
* amazon.com/D5S6-Contact-Cleaner-F5S-H6-FaderLube/dp/B00HNV7WI2?SubscriptionId=AKIAILSHYYTFIVPWUY6Q&tag=duckduckgo-d-20&linkCode=xm2&camp=2025&creative=165953&creativeASIN=B00HNV7WI2

when you are setting your midi track on the mpc are you changing to 2A-Device02 for the 2nd track? 3A-Device02 would be the 3rd track and so on. Let me know if that helps. you should make a new track for each instrument you record from the triton to the mpc, helps when dumping.

korgparts.com

I just changed the key on my Korg Triton Studio 61. It took some time, but it wasn't that hard. You'd better have a power screw driver. I had to take out at least 30 screws.

Do this at your own risk. Don't blame me if you mess up your keyboard. I'm telling you. If you're not that handy, don't try it. Pay attention to detail and be careful.

The Steps that I took

1) Turn your keyboard face down. Make sure you put it on something soft so that you don't scratch the face of your keyboard or damage your knobs or the pitchbender.

2) Remove all the screws on the bottom panel and remove the panel.

3) you have to take the entire keybed out. Lots of screws! I had to remove the "assignable - midi input/output board" to get it out. MAKE SURE THAT YOU DISCONNECT ANY CABLES THAT CONNECT THE KEYBED TO THE REST OF THE KEYBOARD. I had to disconnect the keybed at three different places. These connector cables are NOT strong and if you pull too hard, you WILL break them.

3) Once you get the keybed out, you have to remove the plastic binder that goes at the back of the keybed. It holds the keys in place.

Then Snap the old key out. snap the new key in. Before you unpack your new key, make sure the old one is really broken. I had a key that wasn't broken. It had just come unsnapped. I snapped it back in and it was fine.

Put it all back together again.

I had a broken key before. i got it repaired and it cost me $150. This time I fixed it myself and it cost me $7.50

Have a look through this lot; http://www.korg.com/service/support.asp?A_PROD_NO=TRITONLE Hopefully what you need is in there - please ask again if not :)