Model 417.43042200 Kenmore Washer

SOURCE: Kenmore front-load washer stops at rinse cycle

When the washer initially fills for the wash, is it only hot water entering the drum? Try switching the water temperature between hot and cold as it fills. If any of them show little or no water getting through, it sounds too easy but check to make sure water supply taps are on, and that the cold/hot fill hoses aren't reversed. Remove the fill hoses and check any of the screen filters for blockage (in the hoses and in the inlet water valve). When the machine stops and waits to fill but all you hear is a hum, it sounds like there is power going to the valve but water is not able to get through it.
Good luck!

SOURCE: kenmore washer 417 44252500 does not spin

replaice door swith

SOURCE: Kenmore front load washer, model 417

Washer dryers often have cold water valves with 3 separate solenoids. One for the main wash and rinses (which is clearly ok) and one for the condition rinse (to take the fabric conditioner down) which is probably ok too, and the 3rd one is for the dryer. It's possible this 3rd solenoid has failed.

Washer dryers need on a steady trickle of cold water running into the condenser chamber to convert the steam into water, which then gets pumped down the drain.

e10 means that there is a problem with the water supply.
a condenser dryer needs cold water to operate properly. the e10 code will appear if:
1. the water is turned off
2.the water pressure is too low.
3.the solenoid valve is open circuit
4.there is a problem with the pressure switch (least likely)

Cold valve is at the end of blue inlet pipe remove lid and you will see it.

f E10 is only appearing when trying to dry, the problem almost certainly is the condenser valve solenoid open circuit. The green solenoid on the inlet valve. Should read about 4000 ohms.

My money would be on the solenoid coil being open circuit. The coil can be canabalised from most valves although you may have to modify the connections. For simpler repairs - contact Zanussi and get the entire triple inlet water valve to swap out.


http://www.zanussi-electrolux.co.uk/files/unitedkingdom_english/0-999/zanussi%20error%20codes.swf


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

SOURCE: Permanent Press, Delicate, and Handwash

Hello & Welcome to FixYa

The timer is bad and needs replacement, it fills with water sometimes it even spins and also drains fine so the problem is timer as everything else (motor, lid etc) is working fine. Please get back to me if you have any other questions.

Kevin