Error E17 on my bosch washing machine what does that mean?

SOURCE: I have a front loading bosch washing machine and

Hi harleyd81899,

F17 Turn the tap on fully, check that the supply hose is not kinked/jammed; clean filter. Also check water pressure is not too low If all these test ok you need to run a load with no clothes with 1 cup of white vinegar this will solve your issue.

Regards
R.K.

Karl Wright

• 1653 Answers
• Posted on Oct 23, 2009

SOURCE: what does error f04 mean on a bosch washing

It means that the water is not draining fromthe machine inthe time allowed by the controller.

1. Switch off the machine and disconnect the mains power.
2. Remove the filter and make sure that the filter is not blocked and is clean and clear of all debris. Clean as required. Note that depending on the machine type you may get a lot of water coming out of the filter when you remove it if the machine has not drained successfully. Note that if the machine has stopped and not fully drained then you may be able to drain out the excess water by removing or disconnecting the waste hose and laying it on the ground in a tray.
3. Proceed by checking the drain hose for proper connection and kinks and make sure that it is not blocked.
4. Also check that the main waste drain pipe, if you use one, is not blocked and clean if required.
5. Reconnect the power and switch the machine on.
If the problem persists then do the following.
6. Switch off the machine and disconnect the mains power.
7. Check the electrical connections at the pump and make sure it is operational.
8. Remove the connecting hoses, and expect water to drain out and make sure the pipes are not blocked with debris or any object blockage.
9. Makes sure the pump appears clear and that the impeller looks in good condition.
10. Reconnect the hoses and then reconnect power and switch the machine on.
11. If problem has not been corrected, then remove the pump and check that the drive coupling to the motor is OK and that the motor turns OK. If all is well then replace the pump.

SOURCE: I have E3 error code on a Bosch washing machine

"E3" on a Bosch Maxx means the door is not closed properly. Either there something preventing it from closing properly (blockage) or there is a fault with the locking mechanism.

SOURCE: My brand new Bosch is not draining and is showing E:13 error code

Put the washer on cold and run "TWO" cycles. There is too much soap or fabric softner.

SOURCE: I have a Bosch Logixx

Hi from retired Englishman in SW France,

Same as 'F16', 'F34' stands for 'door lock (fault)' ;-0)

This is indicating that there is a problem either with the door lock or the door locked sensor requiring a service call, sorry ;-0(

If this has assisted and/or clarified the situation for you please consider a 4 thumbs up on our rating.
Thanks and good luck!
John C

Testimonial: "Thanks - the engineer is coming later today. "