Error code F05 after the start of wash cycle

see this causes and fix it. God bless you
F05 Water temperature sensor error If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, or the heating element circuit has failed, the F05 error code will be displayed.

Potential Causes

• Check the Water Temperature Sensor, Heating Element and Element Relay
• Check connections to the Sensor, Heating Element and Relay

Replace failed component.

F05:

Water Temperature Sensor Error

If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, or the heating element circuit has failed, the "F/05" error code will be displayed.

Potential Causes

• Check the Water Temperature Sensor, Heating Element and Element Relay • Check connections to the Sensor, Heating Element and Relay

If this is a Whirlpool model the FO5 error code means:

Water Temperature Sensor Error

If during the water heating step in the wash cycle, the water temperature sensor

(NTC) value is out of range, or the heating element circuit has failed, the "F/05" error

code will be displayed.

Potential Causes

• Check the Water Temperature Sensor, Heating Element and Element Relay

• Check connections to the Sensor, Heating Element and Relay

F/H
F/02

Hope this sheds some light on your problem

kcomp1863

Guessing your talking about a whirlpool below is the meaning and the corrective actionsneeded.

F/05 Water Temperature Sensor Error If during the water heating step in wash cycle, the water temperature sensor (NTC) value is out of range, or the heating element circuit has failed, the "F/05" error code will be displayed.

• Check the Water Temperature Sensor, Heating Element and Element Relay
• Check connections to the Sensor, Heating Element and Relay

If you have anymore questions please feel free to ask, Rich.

the f5 error code is to do with the water inlet valve not working it will need replacing in the mean time try connecting the cold water to the hot select hot wash and see if the water flows into the machine

https://secured.whirlpool.com/Service/.../Duet%20Job%20Aid.pdf
Above is your service manual, look in the area of the NTC sensor,it needs to be replaced, the service manual will show you how.

You need to replace the ntc sensor, most likely.

F/05 Water Temperature Sensor Error
If during the water heating step in wash cycle, the water temperature sensor (NTC) value is out of range, or the heating element circuit has failed, the "F/05" error code will be displayed.

• Check the Water Temperature Sensor, Heating Element and Element Relay
• Check connections to the Sensor, Heating Element and Relay

Water Temperature Sensor Error - Check the Water Temperature Sensor,Heating Element and Element Relay.
If during the water heating step in wash cycle,the water temperature sensor(NTC) value is out of range,or the heating element circuit has failed,the F05 error code will be displayed - Check connections to
the Sensor,Heating Element and Relay.

Hi there,

Well An F05 is a water temperature sensor error.

This occurs if there is a problem detected during the heating step of the wash cycle.

You will need to check the Water Temperature Sensor, Heating Element and the Heating Element Relay.

But as you says that your washer is only 4 months old so why don't you ask for warranty......
Please post comments if you need more help or information........

Good Luck!!

Thanks

F05 means that the pressure switch is jammed on full.
You need to check the pump is pumping out o/k, and if there is a filter, check and clean.

The following link expains the "F05" error code:

http://www.fixya.com/support/r629462-f05_error_code_whirlpool_duet_kenmore

Check to see if the connector is still plugged into the heat sensor, first. I have seen where the connector has come loose and caused this error code. If not, take the resistance readings as recommended. I hope this helps you.