The heater willl turn on for about 2 minutes, then cycles off, theyn trys to turn on again and does, but turns off within 10 seconds. Pressure on the pump is low, pressure switch has been replaced and the temp on the pool is below thermostat setting.
The control module is the problem it allows the heater to come on then turns off power to the gas valve.if you are not getting enough water flow the high limit is turning the heater off then your problem is flow.
Clean your filter first, the water flow may not be strong enough to allow the furnace to stay lit.
Try jumping out the pressure switch on the heater. The pressure switch is normally closed, the water pushes it open. You can check continuity between the contacts on the pressure switch. Even a new switch will still cut the conenction
1,995 views
Usually answered in minutes!
pool heater goes on for a short time then shuts off
My heater would not turn on tech came & changed the water pressure switch. then it turned on but would not stay on. according to him the control panel needs to changed & that might solve the problem is that so
×