Husqvarna YTH2448 wont stay running - Husqvarna YTH23V48 23HP Lawn Tractor 960 43 0086

Pushing the reverse pedal does not stop the tractor? Sounds like the linkage is disconnected or malfunctioning from the controls to the transmission.

YTH2448 HUSQVARNA TRACTOR Manual

Searching Model For Search Your Way yth2448 2

turn on device and wait for response inspect every component for malfunction

Disconsolate the connector from the clutch. Engage the clutch circuit and see if electrical circuit still response as if shorted.

If the response is the same check wiring, switch and relay. Replace/repair defecrive component.

If the response is no problem check the clutch. Inspect the connector at the clutch for broken failed wire connection. Using an ohm meter check for short. The expected resistance is about 3 -4 ohms. If the resistance is less then 1 ohm the PTO clutch is bad. Sorry. It is the solenoid coil has an internal short. Confirm if the clutch is still in warranty.

Check for after market sources for reduced price!
Hope this helps?

Sounds like a weak coil. When cold it's good when hot it loses spark.

I have a husqvarna yth2448 mower whitch the pto switch burns out and pull apart .Blade stop turning and mower remains running

check the wiring to the switch and engine from the switch. if alls there and still hooked up id replace the switch then

I googled yth2448 manual. A site called ubermanuals.com it came up with an operator's manual you can download.
Hope that helps.
Good Day.

It sounds like your charge system is not working. If you jump the battery the engine will run with a weak battery but the pto clutch needs a strong battery to stay engaged.Try this to test it,after you jump it leav the jumper cables hooked up and try to engage the blade clutch,if it runs it is either a battery that wont take a charge or a charge system not working. If you put a volt meter on the battery while the engine is running and the voltage is 13 volts the charge system is working and the battery is bad.