Pride Jazzy 1113 ATS Indoor Power Wheelchair Logo

Related Topics:

A
Anonymous Posted on Sep 20, 2013

Will not charge up has been sitting for along time.

1 Answer

Lawrence Oravetz

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Pride Master 10,558 Answers
  • Posted on Sep 03, 2017
Lawrence Oravetz
Pride Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jul 28, 2008
Answers
10558
Questions
1
Helped
2699926
Points
29284

You need to charge each battery individually with an automotive NON automatic battery charger until at least 10 volts is reached. The chair charger will not charge a battery unless that voltage is present.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Will not charge or turn on tried several methods still will not turn on got it used

If the camera has been sitting around I would suggest that the battery is dead and will not charge because its been not charged in a long time. Sitting without being charged will kill a battery.
Dec 22, 2016 • Cameras
0helpful
1answer

New batteries will not stay charged xxxxxxxxxxxxxxxxxxxx

Just because you have new batteries, it does not mean that the batteries have not been sitting on a shelf somewhere for a long time. When batteries sit for a long time they loose their ability to hold a charge. Return the batteries for a new set.
1helpful
1answer

Bentley continental GT engine stops all power turns off (even hazard warning) key won't come out of ignition

need to check the charging system..when a car sits for a long time the battery should be disconnected or compl,etely removed..sounds like operating voltage is too low check the alternator for stuck brushes or malfunctioning regulator..should show around 14.5 -16 volts..
0helpful
1answer

How you will know that the fan belt need to be replace

I don,t think there a sure way to know,besides a visual inspection for tears ,loose ness .If the car has been sitting along time,or its been over 70 000 miles.Id change it,A new belt could save you a towing charge or more;
3helpful
1answer

My chair was going along fine and then suddenly ground to a halt with just one red light constantly flashing at a steady rate. There is no drive! If you press the horn button a second light comes on but...

If the scooter was sitting unused for a long period of time, the gel inside the batteries may have gone solid and will not allow a full charge. You may need to replace the batteries due to the damaged cells. If you know the brand of controller that is on the scooter, you can look up the lights codes here:
http://www.pgdt.com/scenter/diagnostics/diagvsi.html

Good luck!
2helpful
3answers

My 2008 Dodge Avenger's battery is dead, I have jumped it 4 to 5 times. The car keeps running after removing the jumper cables and the battery charges up enough to restart it a couple of hour later. It...

These cars have become notorious for high battery drain when parked. Coupled with the "exterior illumination" feature that turns on the headlights whenever you unlock the doors remotely, they discharge batteries at an alarming rate when just putted around town. This started happening to ours, and I removed the battery and opened it up (yes, you CAN do that, if you know what you're doing) and sampled the specific gravity. After a low rate recharge, ALL cells were actually a bit on the high side, typical for a cheap OEM battery, but indicating that there was a charge present. After three days of sitting and some cold weather, it wouldn't crank the engine again. The problem appears to be around town driving, along with the unneccesary use of headlights when unlocking, with the high current drain when parked thrown in. Also, the typical cheap Chrysler battery terminals need constant cleaning/burnishing. I highly recommend this and protective grease. Since doing this, I've had some "low charge" incidents, but the car always starts.
0helpful
1answer

Where to find the charging systems

Hi
Trace the positive wire from the battery to the starter. From there it should go to the alternator. It sits along the side of the engine and your serpentine belt drives it. Just make certain you disconnect the battery before you start messing with it.
1helpful
3answers

My microphones don't connect to the base system. I have a ET 18K system from Magic Sing. When I power up the base, I get the audio and video. When I try to power up the microphones, the green lights to...

hey all, althought the manual says to hold down '0' along with the power button, which didt work.

For me it worked by holding '2' then turning on the mic (pressing the power button).

So try all the numbers.
1helpful
1answer

My 1997 Saturn sl2 has a problem with the battery dead after sitting for a month. I charged the battery and took the positive cable off and let it sit for a month and it still had a full charge. Something...

your car will always have something being powered but its a trickle amount[computer-entry control[keyless entry]-radio memory-etc if ur going to let it sit for a month with battery connected yes your battery will more than likely be dead when u disconnect it ur also clearing all codes and memory in computer and components auto stores sell a trickle charger/maintain charge charger for long term storage there used for any type battery boats ,cars,atvs ,planes,etc the charger maintains the charge in a battery it goes on and off when needed
0helpful
1answer

1) Battery dies while car sits overnight. Brand

check the ground to battery and clean posts if need be, also make sure that the alternator is at proper charging rate. a fully charged battery with engine off should read at least 12.5 or higher. when running the battery should read 14 volts or a little higher. clean corrosion from case also if need be. if the above does not work check engine ground.
Not finding what you are looking for?

191 views

Ask a Question

Usually answered in minutes!

Top Pride Health & Beauty Experts

Rob Hill
Rob Hill

Level 3 Expert

1480 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Are you a Pride Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...