Need replacement dish rack

Could be that top spray arm needs replacing if it has one. Or maybe it’s not getting enough water and water valve needs replacing or maybe the bottom spray arm is no longer telescoping and needs replacing

Remove it and make sure it is clean. They work by the water force going through it, if it's dirty the water can't go through and so can't turn.

Hi

If the dishwasher door will not latch on your GE Monogram dishwasher and it is a new appliance, check that the door is not hitting screws or cabinets underneath the counter. For a new dishwasher, you might also need to push in the top of the control panel as you latch the door. The new gaskets might not have had time to seat properly. It may be necessary to run up to 10 dishwasher cycles for the heat from the washer to seat the gasket, which becomes more flexible after it is used a few times. For older Monogram dishwashers, check the loading rack to be sure no dishes are protruding beyond the back or front of the racks and that no dishes have fallen through to the lower rack. If dishes are dangling down into the lower rack, they could stop the lower rack from completely rolling into the dishwasher and could also stop the spray arm from rotating. Check that no silverware is obstructing the door.

http://www.acmehowto.com/howto/appliance/dishwasher/check/doorlatch.php


Let us know if you have something more to know else accept the suggestion.
Thank You for contacting Fixya.com

the spinning arm was loosened,tightened it then test.

Hi, There is a water level switch in the d/w. located in front corner. You can move it up and down while listening for a clicking noise. Sometimes soap will gum them up so they don't move. when it is overflowing, will the water shut off if you turn the machine off or do you need to turn the water off at the faucet?
Please let me know so that I can assist you further.

Thanks
Vic

In regards to the problem with the power switch , I was able to get the 800 number from the store that we bought it at. Called the number-got right through-and they emailed me a COMPLETE breakdown and parts manual for my specific machine.

And I was able to order the part from them right over the phone and it was shipped out immediately. Very pleased with the service. Any one needs the parts breakdown I can email it to them.

Good luck-

Hi,
Here is a tip that I wrote that will help you with your dishwasher not draining problem...

Dishwasher Problems - Water will not drain out
http://www.fixya.com/support/r4078724-dishwasher_problems_water_will_not_drain

heatman101

I know your post is a bit old. I solved this by opening the outer shell and removing all screws attaching the control panel. The power switch needs to be replaced. I looked everywhere (including radio shack and lowes) but sears parts department is the best!

http://www.searspartsdirect.com/partsdirect/getSubComp.pd?modelNumber=DDW399W&productCategoryId=0130000&brandId=3055&modelName=DISHWASHER&diagramPageId=00004&componentDescription=CONTROL%20PANEL&documentId=50031886&backToLink=Return%20to%20Sub%20Components%20list

This should be the link of a diagram and info on the parts. They have just about every screw and bolt you need to repair you Danby. Also they have diagrams to show how it is all put together!

Good Luck!
-Dustin

I have a Danby DDW399W countertop dishwasher. I need a replacement tap attachment and haven't been able to locate one. Email [email protected]