NO GOOD ROM - Furuno GP32 GPS Receiver

try other known good windows installer. if it boot, then the problem is in xp installer, if it not. try other external cd-rom drive. also be sure the disc rom drive are dvd rom drive because a cd rom drive cannot read dvd disc but a dvd rom drive can read cd rom disc installer

Hi! Please make sure that the cd installer has no scratch or dirt on it for its one good reason for not installing. Make sure the the cd rom or optical drive is in good condition. The lens of the cd rom may be dirty so i suggest you run a cd lens cleaner on the cd rom. Then try the installation again. If no luck, i believe that you should replace the cd rom / optical drive. Hope this helps and have a good one!

That is a "Hardware" item it's not "Software".
so purchase a dvd-rom from a local computer shop they should also offer to fit it for you and supply some software for you too.

Hardware = Keyboard, Mouse, Rom Drives, Ect....
Software = XP/Vista, Internet Explorer, Solitair, Ect....

Check the BIOS to make sure that the CD rom is the first boot devices in the bootup sequence, also make sure that the cd rom does show up in the BIOS.
Make sure that the CD Rom itself is good or the boot cd you are using is good, try it on other PC.

Hello there:
Your drive may not necessarly be bad , what i would do is open the case and switch the ribbon from the harddrive and place it on the cd rom and then place the one that was on the cd rom and put it on the harddrive and boot the computer into the bios and see if the cd rom is now showing up.,
If so good which may mean that the ribbon cable that was originally attached to the cd rom may not be good .
But if still nothing than you can put every thing back the way it was and if the ribbon cable that was attached to the cd rom originally has a extra end to hook up to the cd rom try to use it and see what happnes if still nothing than yes replace the drive they usually run about 30 to 60 dollars ok?
best regards michael

yes i think the cd rom is the problem ,use external cd drive for the re installation or you can use a flash disc

* please check dvd rom cable(ide cable) is connected properly

* check powerconnecter is connected tight
jumper settings:
-------------------------

* set ur hdd as master

* dvd rom as slave in ide1

* set master to dvd writer in ide 2

Where can I get the driver for my CD-ROM?
Visit our hardware download section to obtain a generic CD-ROM driver (oakcdrom.sys) and mscdex.exe if needed.
If you are looking for a specific driver for your CD-ROM drive or a Firmware update, please see our CD-ROM driver page.

Dont for get to Vote / Merry Christmas.......Good Luck!

First you want to make sure the CD you are using is good. Try a different CD-ROM, a known good one. If a different CD-ROM is readable then the problem is with your CD media and not the CD-ROM Drive. If another known good CD does not work then the problem is with the drive.

To fix this you must purchase a new CD-ROM drive and install it. Newegg.com has great deals. If you only want to read CDs and are not interested in burning then you can get a name brand CD-ROM drive for around $15.00, but if you need to burn as well the CD+-RW will run you about $30.00.

If you are using Windows XP then it is pretty simple to install the new CD-ROM drive.

It sounds like it may be a seating issue, try to reseat it. if that don't work try another cd-rom.