Merona fmdm121 how to set 3little clocks. - Watches

Not to cast aspersions but it might cost 30% or more of the watch price to replace the battery :)

But yes, you can pop the back off and carefully remove the tiny button cell inside and purchase a comparable battery. I've only seen a couple of Merona watches but both of them had backs that popped off with a Watchmaker's knife.

You have to pull the winding stem halfway out so that it's not fully extended but not pushed all the way in. then you can turn it to set the date. As for the moon and stars, it's to show the phase of the moon. You just have to wind the arms around until you get the moon in the right position. Use this site to set it correctly: https://www.watchnetwork.com/moonphase/index.html

I also have the same problem with my watch.. Just don't know how to set them.

https://www.watchnetwork.com/moonphase/index.html

It's probably fake and just for looks

I've seen some before I think they're just fake

this is all the info available. Try to contact them yourself:
Merona AG
Birmensdorferstrasse 83
CH-8003 Zürich

Tel +41 44 465 80 80
Fax +41 44 463 16 96

E-Mail [email protected]

at the back side of bracelet you can find direction mark, use fine and strong pin with tiny hammer to remove pin out. if there no mark , just look at both side of bracelet, thru narrow hole push your pin, then fastening pin come out thru wider hole

i have a merona watch too. i found wire brads in my garage, then pounded out the pins partway. then i put the end of the pin that was sticking out into a vice grip and pulled the pins out. then remove the link, and use a small hammer to put it back in place. it might take a while, but it works.

You just remove one of the links. I don't think there's a way to set the inner dials. I think it's just for show.