At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: DO NOT KNOW HOW TO USE SAOP/SOLUTION CONTAINER
Soap dispensers only work wit no or low pressure nozzels. when you have high pressure nozzles there is too much back pressure for the soap dispenser to function ..
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
sometimes hard water and saop causes it to stick, u can use a 2 by 4 to pray it up by placing a pc of rope under it and either use ur hands or a pc of would or something on both ends and pray up hard, be careful Ive busted a lip or two b4 but its works
To make your bar saop last longer, remove soap from all packaging and them AIR out in the linen closet, spare room etc. Discard the soap bar boxes in different trash containers in your home for a quick freshen-up.
It is simple find a clean container.From the tank you will find the fuel valve and the fuel hose connected to your carburator. First close the fuel valve, if it is easier to remove the hose from the carburator, remove it and to put it to your container. Open the valve to drain the gasoline. Otherwise take a rubber hose about half meter of the same size and put one end of the hose to the container, disconnect the fuel hose after the valve and connect the other end of your hose which is in the container. Open the valve to drain the gasoline to the container.
this is actually normal, it is going through a purge cycle,
draining, checking water temp, checking water fill
the longer the cycle, the more it needs to check
this coud be remedied by cutting back on your saop a bit
less suds
believe it or not
DISHWASHING detergent not saop
it is best to use the dry crystls since this will be you srcubbing action
1 cup run the load on warm not hot
Does water squirt out of the hose nozzle, if it does, then check the heater inside the handle asm. Make sure that where the tubes hook up to it are not clogged. If water doesn't squirt, check for the seal at the bottom of the tank, it needs to be on the tank, not in the hole, this is for the soap bottle also, there is a seal on the bottom of it as well. The flow indictor cap is leaking air or maybe is too tight. If you had the top cover off, make sure that the tubes are routed right so as not to get pinched when the cover is put back on, the smart mix knob should be in the water setting and that the piston is on the bottom of the smart mix knob. Pump is bad. Try running a mix of vinegar and water to see if that unclogs the lines. Is the top cover and the base tight together in the back, sometimes the top breaks loose and it will raise up and it can't spray, just re-fasten it down.
Low water pressure. Caused by not enough water in machine (water valve or house water supply). Also could be pump screen is clogged up (bad chopper assembly) Also could be caused by spray arms themselves being clogged. (goes hand in hand with pump screen being clogged) These are the 3 most common problems i have seen and all could cause low water pressure in the machine. This is assuming the dispenser door is opening!
×