Don't turn - Samsung Digimax S730 Digital Camera

Could be several things. But first make sure that the turn signal flasher is good. It is different than the 4 way/emergency flasher.

more than likely the bulbs are burnt out.

the problem is when you don't turn on the ac on and don't turn on the engine withou turning on the ac because than you won't be able to have any air and call the company of the car to fix the fan for you

Dash board or gages

there's a little plastic piece inside the turn switch called a cancelling cam that broke or quit working. The only fix to get switch to return is replacing the turn signal switch. I don't think you can buy the part separately.

if your hazzards flash, that means your bulbs will be good but, your turn signal fuse is blown. you should check that first, & don't forget to turn off your hazzards before you can see if your turn signals work again. give it a try.

Follow the instructions step by step

1. Turn off printer, cable power still plug in,
2. Press Stop/Reset button don't release
3. Press Power Button don't release and than release Stop/Reset button
4. Press Stop/Reset button 2X , wait until service mode to " 0 "
5. Turn off printer, cable power still plug in
6. Press Stop/Reset button don't release
7. Press Power Button don't release and than release Stop/Reset button
8. Press Stop/Reset button 4X , wait until service mode to " 1 "
9. Turn off printer, and loose cable power, wait one minute.
10. Connect cable power, turn on printer again, now this printer ready to use.

It might not start because of a dead battery, starter. Altenators charge the battery. I wouldn't consider buying it, If I counldn't hear it run.

Contact me directly at [email protected] and I'll send you a trouble shooting guide for the turn signals. Don't forget to remind me of what you need.

Steve

It's probably the turn signal flasher. It is usually located under the dash along with the hazard light flasher. If you don't know what it looks like, then go to a parts store and look at a new one. Once you have located one, then remove it. Try the hazard flashers. If they work, then replace that flasher with a new one. If they don't, then reinstall that flasher and look for another one like it. When you find one, replace it with the new flasher and try the turn signals. (remember : the key must be on for the turn signals to operate). I hope this information helps you and thank you for using Fixya.com.