My ooutdoor tecnology tags are not charging on my mac when I plug in I keep swicthing plug in port . Any Ideas??

Doesn't it have a USB charging port? Get the cable that fits that port and plug into a USB charger (like a phone charger) or into a USB port on the MAC

Check the muffler for any type of obstruction first. Then I would check the diaphragm in the carburetor to make sure it isn't starting to stiffen up. If that doesn't help it may be that it is just old and tired

If you need further help, I’m available over the phone at https://www.6ya.com/expert/kelly_69a0cf1b13789df1

Switch learns network MAC addresses And controls the network packets to reduce broadcast packet traffic on your network !
INTERNET V MODEM V Back of router ethernet port 1 V ROUTER AS AP Wi Fi Back of router ethernet port 2 V Switch Port V V

-> STATION Client/ /CLIENT ' Local/Lan

or

INTERNET V MODEM V Could Place Switch in Here instead Switch Port V V V ROUTER Station V AS AP Wi Fi client V V Client/ Local/Lan

This usually means that your battery is not holding a charge anymore. You will have to replace your battery. A cheaper route is to keep it always plugged in.

Did you try to disconnect the battery and connect you mac book to the charger? If it turns on with the power connected and without the battery, probably your battery is broken.

There is an extensive post on this site that may help you out. Click here My adapter won't charge my mac notebook..and the computers fan ...

My MP600 came up error 306 for no reason. I unplugged everything and plugged it back in again (I found a clump of dust at the USB port on the hub, which could have been involved) - the printer worked again no problem.

Normal 0 Try disconnecting the Mouse Receiver from the USB port and reinstall the CD software program. When the program asks you to connect the Mouse Receiver to the USB port, do so and it should work.
Hope this helps. Bud

%SYS-4-P2_WARN: 1/Tag 0 The switch generates %SYS-4-P2_WARN: 1/Tag 0… messages.
This example shows the syslog output that you see when this error occurs:
%SYS-4-P2_WARN: 1/Tag [dec] on packet from [ether] port [chars],
but port's native vlan is [dec] This message indicates that an 802.1Q-tagged packet was received on a nontrunk port. The VLAN that is derived from the packet tag is different from the port native VLAN. In the error message:

• The Tag [dec] is the VLAN identifier from the packet.
  
• The [ether] is the host MAC address.
  
• The port [chars] is the port identifier.
  
• The second [dec] is the native VLAN number.
  

There is a possibility that the local port is incorrectly configured as an access port instead of a trunk port. Alternately, the remote side can have been configured as a trunk port instead of an access port.
Verify that the local port is not incorrectly configured as an access port instead of a trunk port. Also, verify that the remote side is not configured as a trunk port instead of an access port.

Might be your USB port. I see USB ports go bad everyday. They are frail little things.