How to fix service call C14A3 for ineo 213 - Konica Minolta Di1610 Copier

Reset the drum and developer counters to zero, the replace the developer, and run the required TCR adjustment. Do NOT reset the counters then think you don't have to replace the drum and developer, because the copier uses the counters to determine voltages for certain parts inside the machine, reset counter and not replace the parts the copier thinks they are new when in fact they are old you get codes and bad copies.,

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

The ATDC control voltage was within the range of 5.39V to 8.15V when function F8 is run.

C14A3 means IR fluorescent lamp fault. Check the Exposure Lamp (LA2) . The Scanner Exposure Lamp fails to turn ON. Test the voltage supply & the Lamp.

http://farbtoner.com/develop-ineo-c-200.html?language=en

The bright that normally come on under the big glass is having issues, replace the scanner assembly can't just get the lamp.


try this web site for starters


Precision Roller Printer Toner Cartridges Parts and Supplies Office...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

main board problem

Replace the drum and developer.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

drum replacement and developer.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Develop ineo 213

unless the drum and developer are replaced not a good idea to reset the counter. causes codes and image problems

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f